the oil was full in the crank case but that didnt include the filter which holds another prolly half quart. prolly less. its differs. but reguardless when you start it and shut it off and check it again its gonna be a little low...
I like to start the car and look for any leaks after I replace the oil. Then I shut the engine off and check the level of oil in the engine. The amount of oil needed to fill the new oil filter is going to affect the reading on the dipstick.
On engines where the oil filter is not upside down or sideways, I like to pre-fill the filter with fresh motor oil instead of installing it dry. Pre-filling the filter with oil reduces the time it will take for the engine to build up oil pressure on startup.
This truly makes me understand the steps that i'm going to be doing in a oil change i'm a high school student and this is a good way to learn...Thank You.
this video left so much shit out. before u do anything u need to start the car and let it warm up for at least 5 minutes. then u pull the dipstick so when u drain the oil it flows right through quick . god i need to make ma own videl. god dont u ppl pay attention when u go to the mechanix.
you wont get a whole lot of air thru the dipstick tube. the best way to ensure the oil flows out quickly is to remove the oil filler cap. but i prefer to keep them all there, to keep the oil from going too far from the plug. the way i do it it takes 30seconds to 1 minute to drain, but it falls right below the plug, so i dont spill any.
This is my poem
Ginger ale and a bottle of wine
Ginger ale and a bottle of swine
Ginger ale and a great big pine
Ginger ale and a watermelon rind
Ginger ale and what's with this lime
Ginger ale and I have some slime
AND PROFESSOR PONY ROCKS!!!!!!!!!
MrKittytoenails 8 months ago 2
the oil was full in the crank case but that didnt include the filter which holds another prolly half quart. prolly less. its differs. but reguardless when you start it and shut it off and check it again its gonna be a little low...
chevyblows2001 8 months ago
Thx helped me on my final examines ;)
eacorion 9 months ago
Dont forget the blinker fluid! lol
PVoyager 10 months ago
I like to start the car and look for any leaks after I replace the oil. Then I shut the engine off and check the level of oil in the engine. The amount of oil needed to fill the new oil filter is going to affect the reading on the dipstick.
CP240sx 1 year ago
hey what bout the fuel filter?
TheChessmaster09 1 year ago
did he just say battery water? at 0:12
manout234 1 year ago
@manout234 Yes, automotive batteries can be topped up with (distilled) water.
Ge1Force 1 year ago
What a cool guy
mobbsmcg 1 year ago
i love his enthuisiasm haha
ChinoAntraxXx 1 year ago
what size wrench do I need to remove the oil drain plug (chevy cavalier 2002) thanks
moskitonetski2 1 year ago
@moskitonetski2 - A typical socket set will have any size socket you need to remove the oil drain plug.
HiTechOilCo 1 year ago
no honda love in this vid
osvaldo2k5 2 years ago
great video
napkin180 2 years ago
it had to be from the 80's or early 90's lol
MattSackable 2 years ago
haha when was this made? I love his Mullett!
Rare92Mustang 2 years ago
@Rare92Mustang - Why would you like his, "Mullett", English fish soup?
HiTechOilCo 1 year ago
On engines where the oil filter is not upside down or sideways, I like to pre-fill the filter with fresh motor oil instead of installing it dry. Pre-filling the filter with oil reduces the time it will take for the engine to build up oil pressure on startup.
TranceScene 2 years ago 9
@TranceScene I totally agree, and even when alot of people disagree, What can it hurt?
Rare92Mustang 2 years ago
Comment removed
TranceScene 2 years ago
this is a nice general video, but it wont do much good for some cars. its better if you see a video made by changing oil on a car like yours.
pepene93 2 years ago
This truly makes me understand the steps that i'm going to be doing in a oil change i'm a high school student and this is a good way to learn...Thank You.
Crazyboy13Z 2 years ago
this video left so much shit out. before u do anything u need to start the car and let it warm up for at least 5 minutes. then u pull the dipstick so when u drain the oil it flows right through quick . god i need to make ma own videl. god dont u ppl pay attention when u go to the mechanix.
feefster420 2 years ago
Make your own video and stop bitching, then.
realdimension 2 years ago
you wont get a whole lot of air thru the dipstick tube. the best way to ensure the oil flows out quickly is to remove the oil filler cap. but i prefer to keep them all there, to keep the oil from going too far from the plug. the way i do it it takes 30seconds to 1 minute to drain, but it falls right below the plug, so i dont spill any.
pepene93 2 years ago
ThANK YOU, sir
iflylo01 2 years ago
that oil he poured in looked used castrol is usally way clearer than that. good video though.
1dickweed1992 2 years ago
@1dickweed1992 - Castrol is manufactured by BP, or British Petroleum, the infamous company of the massive oil spill in the Gulf of Mexico.
HiTechOilCo 1 year ago
when u start the car the new oil filter will suck in some oil so dont check the dipstick right after oil change
patryksko 2 years ago
the BEST overall car maintenance video by far on basic care care. Thanks for the video!
major2 3 years ago
thnks .. really useful tips ..
praji2004 3 years ago 3