stepper motor PIC-based position and speed controller

[tpioneer]

hey, could you showm me your program for the PIC?

[nudeforfun]

I need to buy something like this. I need to run a stepper motor in each direction a little bit with two push buttons, forward and reverse, or one button and reversing switch. I will pay $. Help luvfilm@gmail.com

[CognitiveNetwork]

What is the difficulty level of this thing compared to building an Ambient Light Ignoring Infrared Motion Detector which consists of a timer as osciliscope, LED, Phototransistor and two operational amplifiers, along with their respective capacitors, resistors, potentionmeters, and one RLC frequency filter?

[tummeta]

could you show me the circuit. I have to use stepper motor in my project and i can only control direction of rotation but i can't control speed of rotation. I need it very much, thank you.

[mszazlina]

plssss teach me how to do thiss

[CognitiveNetwork]

@mszazlina No offence, take a bachelor degree in mechatronical engineering. Study digital control and electrical engineering (1 basic major)... you need to study how micro controllers work later on.

[MandrewP]

Finally, a decent video!

[rong111y]

I think it is not 100% right to put "position" to title this video cuz you only use a PIC to control the speed, and the angles 45 and 180 degrees that the stepper motor could posibly rotate. Sorry if I misundertood your title. what I really want is the arrow could rotate back to its original position where is mentioned to be "0 degree" on your video after the system has been rebooted. is it possible?

[djthomeke]

is it possible to make the steps go smooth because now they snap to the next position, so can you add a fade in to it ?

Can you send me an cirquit diagram because i want to make this board to but i can't find a schedule of it

[emu871]

hi,

i am in need to drive a stepper motor but the motor that i have that have only 5 phase and it dsnt have any wire of ground,

would you please help me how could i drive it and which type of driver i can use...

[rboghdady]

Good Job