Thanks, I will have to hit them again... They are rolled up nice but not quite flat. Critical area is from 10 to 2 right? Have you been a top contender in DSP in your area? Thanks Mark.
That's exactly what I run. I rolled the rear pretty good... it's like flat now, as long as you get a lot of heat on it, it'll be all good with the mallet.
Hey Mack, What size tire do you run on the rear? I have a set of 245/40/17 Hoosier A6's for 2010. I rolled the fenders a little with some heat and a rubber mallet, do you think it will work. Thanks Mark.
What are you doing about Camber ADJ... Can I get enough out of the stock setup, I only changed dampers.
StupidMonkey7024 2 years ago
I have camber plates up front and camber arms in the rear.
tigermack 2 years ago
Thanks, I will have to hit them again... They are rolled up nice but not quite flat. Critical area is from 10 to 2 right? Have you been a top contender in DSP in your area? Thanks Mark.
StupidMonkey7024 2 years ago
Yeah, 10-2... depends on your height, you might need to trim the rear bumper... it rubs there sometimes. Only if you're low.
I run FSP. My car is not a MS3.
tigermack 2 years ago
That's exactly what I run. I rolled the rear pretty good... it's like flat now, as long as you get a lot of heat on it, it'll be all good with the mallet.
tigermack 2 years ago
Hey Mack, What size tire do you run on the rear? I have a set of 245/40/17 Hoosier A6's for 2010. I rolled the fenders a little with some heat and a rubber mallet, do you think it will work. Thanks Mark.
StupidMonkey7024 2 years ago