They should. Drop fowards have 2 different types of attachments. In line screw, and off set screws. They are now being made with both inline and offset. So I think it should be fine.
And also is the Tadao Spyder VS Marker Board good for my vs1 which is the exact one you are holding in your hand except without the whole drop thing and ASA stuff and where did you get that?
Hey i was shooting my Vs1 for the first time in a while and i noticed that it was shooting like 3-4-5 balls at a time and i was like WHAT?? and i noticed that tha bals were coming out of my barrel!! so how do i replace my ball detents?? what do i do to get them and install them?
It sounds like it is the detents from what you are describing. To replace the detents, unscrew the "eye covers" there, you will find the eyes and another little hole near the eyes. These are the detent holes. They should be plugged in by a detent. If they are there, take them out by taking off the barrel and pulling back the bolt and sliding your finger inside the breach and popping them out. Inspect them for wear. But it sounds like you need them replaced. Unfortunately, idk where to get them
the eyes sense if there is PB in the breech. It makes it so that the gun WILL not fire if there IS NOT a pb in the breech. this prevents chops, and EVERY gun should have them
Read the Manuel. if you lost it, read it online. i cannot remember, i have sold the marker along time ago. but it is the setting where it shoots the slowest.
Something similiar happened to me when I took out my bolt. it flew and alomst hit my dad's car, so what can I do took take out the air in the gun, so I can safly take out the bolt and not make the same mistake?
If you have an on/off ASA, slowly turn it OFF untill it starts leaking and when it stops (it leaks from the reg and the gun, not the tank) turn it all the way and you can take out your bolt. or you can unscrew the the tank and take it off. But you shouldnt need to be taking out the bolt while aired up if you have been maintaining the gun.
for the vs1 when its liek that with no air, it only sounds like with the eyes on it sounds like it shoots less, whe u have paint and air in it, it shoots as fast as the pb's get in or 20bps
hey im new to paintball so i was looking at the vs1 and it looks awsome but i only have $100 4 upgrades wat should i buy first to improve it as good as possible
my dad had a 99 cocker when he still played, he gave it to me but i fail to reconise its importace as a collectors item thinking the newer ones are more valuable. long story short i sold it for 80
so when i have my tank in dont take the bolt out
mast3erb3ar9 1 year ago
@mast3erb3ar9
That's always a good thing to not do with any marker.
sjking92 1 year ago
@sjking92 normally the air presure keeps the bolt in, and btw spyders r fucking gay i only watched this cus i was board get a real gun
LEGIONofDOOMpbteam 3 months ago
@LEGIONofDOOMpbteam
This video was filmed in 2008.
Congrats. I do own higher end markers, and "real" guns.
sjking92 3 months ago
hey do u know if the ans drop forward for spyder will fit this gun????
PBZeno 1 year ago
@PBZeno
They should. Drop fowards have 2 different types of attachments. In line screw, and off set screws. They are now being made with both inline and offset. So I think it should be fine.
sjking92 1 year ago
@sjking92 ya its not that expensive i was just wondering thanks dude
PBZeno 1 year ago
where in texas?
DeeOhhDoubleGee 1 year ago
And also is the Tadao Spyder VS Marker Board good for my vs1 which is the exact one you are holding in your hand except without the whole drop thing and ASA stuff and where did you get that?
mando2394 2 years ago
and by the way i love your videos!!! the y help aot thanks!!! please help me out!! i NEED YOU!!! ha ha no homo:)
mando2394 2 years ago
Hey i was shooting my Vs1 for the first time in a while and i noticed that it was shooting like 3-4-5 balls at a time and i was like WHAT?? and i noticed that tha bals were coming out of my barrel!! so how do i replace my ball detents?? what do i do to get them and install them?
mando2394 2 years ago
It sounds like it is the detents from what you are describing. To replace the detents, unscrew the "eye covers" there, you will find the eyes and another little hole near the eyes. These are the detent holes. They should be plugged in by a detent. If they are there, take them out by taking off the barrel and pulling back the bolt and sliding your finger inside the breach and popping them out. Inspect them for wear. But it sounds like you need them replaced. Unfortunately, idk where to get them
sjking92 2 years ago
whta was that second gun?
anndrooob 2 years ago
An OLD VL vigor i think
sjking92 2 years ago
i still dont understand wat the eyes are for n wat the do?
vx1000sk8er 2 years ago
the eyes sense if there is PB in the breech. It makes it so that the gun WILL not fire if there IS NOT a pb in the breech. this prevents chops, and EVERY gun should have them
sjking92 2 years ago
dude that story about the kid killing his mom ruined my day =(
ifyadontplaypburlost 2 years ago
The entire community went into lamentation, party because of the bad rep we got.
sjking92 2 years ago
hey how do u put eyes on is it standard when u turn it on or do you haaave to hold it down but if you hold it down than it turns to three round burst
trebor3255 2 years ago
Read the Manuel. if you lost it, read it online. i cannot remember, i have sold the marker along time ago. but it is the setting where it shoots the slowest.
sjking92 2 years ago
This comment has received too many negative votes show
haha fag vs1 get a better gun and its not affecting me if u put low rartings onmine atleast i dont disable mine pussy
pollolocito17 2 years ago
i sold the vs1 project and bought the pmr. i also have an etek 2 and some old shoe box markers.
"atleast i don disable mine pussy"
^^^ try again. making a pussy not work...?
sjking92 2 years ago
no the kid took of the whole tank including the regulator whoch flew out of his hands and smacked him
jaicensolo543 2 years ago
yeah, that was it
sjking92 2 years ago
how are you taking your bolt out like that mine doesnt lift like that
distortedfears 3 years ago
all of them do. lift harder.
all of them should, if it doesnt return it.
sjking92 3 years ago
never mind
lcs2834 3 years ago
Something similiar happened to me when I took out my bolt. it flew and alomst hit my dad's car, so what can I do took take out the air in the gun, so I can safly take out the bolt and not make the same mistake?
kcbros151 3 years ago
If you have an on/off ASA, slowly turn it OFF untill it starts leaking and when it stops (it leaks from the reg and the gun, not the tank) turn it all the way and you can take out your bolt. or you can unscrew the the tank and take it off. But you shouldnt need to be taking out the bolt while aired up if you have been maintaining the gun.
sjking92 3 years ago
your school has paintball wow !
paintballwanttobe 3 years ago
ncpa, a club, not a school team. but a team made of school people
sjking92 3 years ago
for the vs1 when its liek that with no air, it only sounds like with the eyes on it sounds like it shoots less, whe u have paint and air in it, it shoots as fast as the pb's get in or 20bps
phungsta 3 years ago
it shoots 13 with eyes on. 20 eyes off. same with paint and air in. take it to the field and turn the chrono to the bps function. its 13 and 20.
sjking92 3 years ago
hey im new to paintball so i was looking at the vs1 and it looks awsome but i only have $100 4 upgrades wat should i buy first to improve it as good as possible
PaintballBros9598 3 years ago
barrel i dont own spyders i hate them but the first thing i upgrade on all my guns is a new barrel
trevor62120 3 years ago
well wat kind of gun do u have
PaintballBros9598 3 years ago
ego7 ego8 and a 1999 wgp autococker and a ans gx4 autococker
trevor62120 3 years ago
those r some nice guns i got a tippmann 98 custom its good for woodsball
PaintballBros9598 3 years ago
yeah i had an a-5 good guns but i got into speedball
trevor62120 3 years ago
my dad had a 99 cocker when he still played, he gave it to me but i fail to reconise its importace as a collectors item thinking the newer ones are more valuable. long story short i sold it for 80
sjking92 3 years ago
damn if you still had it i would of bought it
trevor62120 3 years ago
if i knew how valuable they are i WOULDNT have sold it.
sjking92 3 years ago
yeah old cockers are really valuable i can sell my 99 cocker for 700 bucks with everything on it
trevor62120 3 years ago
dont evan get the vs1 go on ebay and get a used evil gun or somlthing like that
samuri8000 3 years ago