The quick answer is just go into Skeinforge/Settings/Quick Edit and change the Feed rate and Flow rate values to 50.
The months of preparation that led up to being able to do that are summarised in a post called "Skeinforge Configuration" in the RepRapHuxley Prints section of the RepRap Huxley forum.
The quick answer is just go into Skeinforge/Settings/Quick Edit and change the Feed rate and Flow rate values to 50.
The months of preparation that led up to being able to do that are summarised in a post called "Skeinforge Configuration" in the RepRapHuxley Prints section of the RepRap Huxley forum.
Good luck with your build.
microcubology 1 month ago
Hello…
You have a nice looking printer. I am building a RepRapPro 3d Printer.
The 50mm/s speed seems to be working fine with your configuration. I would like to know how you set this up.
RepRapPro 1 month ago