He's turning with the piece going clockwise (down on the right) so it only looks like he's doing it the opposite. I've turned a few pieces like this that had a trouble grain. Or, you can get twice as much cut time between sharpenings if you switch directions...
Waaahh !
*You* left the key in the chuck !
orangmakan 1 year ago
so hold on im abit confused. was the lathe spinning the same direction all the way through the vid??
ALEXTHECATYEAH 2 years ago
Nice hollowing. What was the filling wax that you used to the crack in part 1 ?
SSbySamiSorvari 2 years ago
I am left-handed, it is hand
droti58 2 years ago
Hello
carnauba wax at the end of the handle
droti58 2 years ago
what are the compounds he is putting on at the end?? looks like to big polishing compounds or like pieces of chalk....
metal0artist0kyle 2 years ago
optical illusion its turning the other way!!!!!!
dingo585 2 years ago
He's turning with the piece going clockwise (down on the right) so it only looks like he's doing it the opposite. I've turned a few pieces like this that had a trouble grain. Or, you can get twice as much cut time between sharpenings if you switch directions...
SjustaSnake 3 years ago
Why are you hollowing out from the opposite side from every instruction book I have ever seen?
Mike
mpax356 3 years ago