Added: 4 years ago
From: sirHOAX
Views: 18,910
Sort by time | Sort by thread (beta)

Link to this comment:

Share to:
see all

All Comments (46)

Sign In or Sign Up now to post a comment!
  • sirHOAX - what happend to your channel ! . . . . is this clip from part 6 of Bedini's videos?

  • 3.7 times 5 equals 18.5 Amps. Am I right? I thing afterwards you give your solar panels to your neigthbors ;-))

  • Free energy can change the world!But a few ppl make too many billions from our energy needs to let this technology be known,Check this free energy magnet motor at LT-MAGNET-MOTORdotCOM ,Be the revolution!

  • Comment removed

  • Another HOT-AIR expert.

  • Comment removed

  • You have no basis for providing any type of expertise on this subject. Your more than welcome to build this and prove otherwise. Will be patiently awaiting your project build. Until then your just another HOT-AIR expert.

    Good Day Sir.

  • The voltage spikes are an indication of the coil collapse that is collected and furnished to the battery(s). These potential spikes charge the battery in an unconventional way. The energy is not measurable going out of the machine (other than the spikes), but is found in the battery after it becomes charged resulting in extended run times when powering loads. The batteries become charged, but not with current so current out of the system does not indicate charging ability. try it, it works!

  • ok so this thing is opening a gate in the magnets and also pulling ambient energy around the coil, the spike is not the energy discussed (radiant) but is only the trigger to pull the energy in that can't be seen on standard equipment? is that about right?......I want one of those!

  • I know it's been a year since yo upload this video but it's still nice to know what's the update to this motor. Are you still using this? Still functional? Any update about it? Would be nice to know.

  • THERE IS NO SUCH THING AS MONOPOLE MAGNETS!

    Permanent or electromagnet!

  • Its called Dirac's monopole. It is one of the fundamental solutions of Maxwell's PDE-s. So it exists, theoretically.

  • " lol....energy is never created..."

    That is beside the point. If more energy comes out the "out" port than goes into the "in" port then you should be able to hook the out to the in, give it an initial pulse, and then it should be able to self-sustain.

  • What about the charging CURRENT??? Nobody ever says anything about that and that is the most inportant thing! What do you do with 20 volts anyway,,,TOY,,,,you need 240 volts 50 to 60Hz and 200+ amps,,,,,can you do that????,,,Maybe,,,,MAYBE I can run a LED flashlight off of a $3000 bedini,,LOL, I know what the problem is so watch you tube for CQDXS' version of this motor,,, you'll see, all I can tell you is it uses telephone pole transformers and magnets the size of 5 gallon buckets!!!

  • LOL... the current is created in the batteries, ions are forced to 'ring' by hammering them with the FE spikes the batteries then charge themselves. 20volts is plenty coupled with the current available in the batteries to then run mains inverters. Think outside the box.

  • think outside the box what da hell are you talking about ??????

    is it so strange that someone asks informations about the input and output current and voltage ??

    you know what ?? I need those infos too...

    what's the input voltage and current?

    and the output voltage andc current?

    please..someone gives us those infos..

  • machines that pulse DC current are drawing fro the Zero Point Energy Feild, known now as Dark Energy... which used to be called Zeropoint energy

  • Wow..I want to build one. Any plans availble?

  • Eliminate the batteries and use all the created extra energy to run the motor. If you can't do that then it is a hoax.

  • But, I like the motor spinning and making all that generating noise, I rather have the Motor running than to use a silent spikey charger !!! So Don't worry John (Bedini) at least your invention has helped me to think a bit wider, so let us not rule out this possibility that the Lead acid batteries charge quicker and with less power thanwhen charged with a high voltage spiky wave than a steady DC voltage, whatever, the outcome is definitely looking good! I don't know the Chemistry on bateries.

  • Continued.... yes so what if the secret is in the way the batteries get chemically charged using the high voltage spikes generated by the Bedini Motor, thats what it does, so it may be quite possible that the trick or secret is in the use of spiky charging method as opposed to a steady DC voltage charging batteries, this I will have to see, if this is the case then we don't need a Bedini Motor to do that, we can generate High Voltage spikes electronically without all that noise!!!

  • I made a smal version with a single coil, but i need some batteries first to seriously test the accailim, that instead of 1 battery runing the motor ends upcharging a bank of battereies, so even if it charges two batteries from fully discharged state to full capacity, then thats good enough contraption.

    May be its nothing to do with power being spent in running the motor against the electrical power being outputed being less than what is going in, but ........continued above

  • Very bad video !

  • My worry here is that the 12% duty cycle is the key to understanding how it appears to have more out than in. 10W in 100% of the time will give 980W out 1% of the time if it is 98% efficient. :(

  • All I know is this thing sounds like a well engineered machine, that appears to self-run.

    So no skeptics are welcome in this arena..

    --heh-- :=)

  • Can you be more specific re: the phrase 'appears to self run' ? Also, We see input voltage and current and output voltage but no output current, if this is running and charginbg from separate batteries, it can only 'self run' if the output is at least as much as the input, Power = Volts x Amps

  • @sirHOAX what happens if the coils are offset? like a rotatory engine at 10 degrees, does it even out the voltage spikes to more of a square wave?

  • Peter Lindemann states that it will work on a video hear on u tube

  • have you tried it, stan meyers used the same kind of spikes to pulse up the water cell. i read somewhere that the this motor can cause battries to explode i figured that might be, because HHO is being created.

  • forget charging batteries use the voltage to electrolises water for HHO producton. Store the energy in the form of HHO so it can be used at will, not at the batteries C20 rate. pipe the gas into the intake of an internal combustion engine. imagine.

  • The voltage that charges the batteries does not do real world applications. It is radiant energy that is seen in the form of 1000volt spikes at EXTREMELY short intervals. The intervals are so short that modern day electronics can not replicate the pulses.

    It will not work in electrolysis, unless its taken from the batteries.

  • actually it will work for regular electrolysis, but since the amps are so minimal so is the gas output. i had read somewhere that someone hooked a cell up to a bedini sg and had gas "streaming" off the plates so being i had both sitting around i decided to see myself. my SG is a small single coil unit though so i would like to see what one of these larger designs would produce.

  • The radiant energy they speak of is for charging potential across the battery. They are only pulling around 3-4Amps real world measured with analog/digital multimeters. Its all in the ocsilliscope traces watching the frequency of the spikes, finding and tuning these frequencies. Coil design also plays a large role. --S

  • @sirHOAX

    I've read in chapter 10-47 on resonant electrolysis in "the practical guide of free energy technology" available at free-energy(dot)co(dot)uk/PGKB­ook(dot)html That a bedini monopole can be adapted to a water splitter circuit.

    I swear to you it's legit.

  • if this was years ago can you imagine what they have now!!!!

  • What is the point of this contraption ??

    Does it do anything useful ??

  • Cool! Do you know if all the coils were firing similtaniously?

  • So power in equals 3.5 amp x 24.8 volts= 86.8 watts. Power out(to charge batteries) equals amps x 26.19 volts. I wonder what would be the amps out ...or does that really matter here?

  • I don't think that is the output voltage. Thats the voltage of the charging batteries isnt it? But good question... i see people always looking at the output voltage but only half the time they look at the amps which is just as important. Though the output voltage and current realy dont matter since the energy that charges the batteries doesnt show up on the meters anyway!

  • nice i want one !!!!!!!!!!

  • thanks for gettin it back on!!!

  • where can i get one? Booo - Yaaaahhhh

  • Build one.

  • hmmmm.... looks kindof familiar lol. MAN WHEN ARE THE REST OF MY MAGNETS GOING TO GET HERE!

  • I admire your work, I hope you do not sell out in the end like I am sure many others have done in the past. Cheers, 5 stars.

  • This is the work of Tom Bearden, John Bedini, and Peter Lindemann.

  • Yep, I know that is Peter Speaking.

  • now that is a fine piece of machinery, any chance of data over time? Input v,a and output v, a?

  • couldn't see clearly enough, what was the output on this one? I saw it spiking like crazy, one hell of a machine!

Loading...
0 / 00Unsaved Playlist Return to active list
    1. Your queue is empty. Add videos to your queue using this button:
      or sign in to load a different list.
    Loading...Loading...Saving...
    • Clear all videos from this list
    • Learn more