Make sure you are not using the center of the pad to print. Your image should be above or below the center. This will get rid of the voids in the center. I have trouble with voids on the edges as well. Try printing about 50 hits on a piece of paper. They should go away after that.
Listen i made the print work it was the Plate and ink, Now Very good print. However, i noticed small bubles or dots in some areas of the print. Especially in the centre and some on outer edges - but outer little bubbles change from print to print... so could it be the pad?
What pad you suggest for pens with printing text on it. What i have right now is same pad as yours rectanglar one in this video...
Is that a lego fixture?
asuranyi 6 months ago
Yes, LEGO bricks work great for basic fixtures.
djkees123 6 months ago
This has been flagged as spam show
Trung Tâm phân phối máy in HanSeng tại Việt Nam._ CTY Cổ Phần Công Nghệ Sao Phương Nam.
- Cung cấp máy in lụa, máy In tampon, máy truyền nhiệt.
- Các phụ kiện máy in.
ĐC: 0011 Bạch Mã, P.15, Q10, TPHCM.
DT:0862646980
Mr Thái : 0916469291
tranquocthai234 7 months ago
nice job :)
skrulonair 11 months ago
Lookin into one these machines, how much did that one run you?
latinofino619 1 year ago
@latinofino619 about $6K
djkees123 1 year ago
howww booooring of a job
whereswalid 1 year ago
@whereswalid I do this, theres a lot more to it. Designing, sales, you should step your game up its called hustling. Dont be afraid to work hard
Phuckyooo 1 year ago
Comment removed
fanofheadroom1 1 year ago
Comment removed
fanofheadroom1 1 year ago
that looks so much fun
auzio 1 year ago
I like the homemade Lego jig.
DoubleDoubleEveryday 2 years ago 2
what kind of machine is this ?
tbenefi33 3 years ago
Make sure you are not using the center of the pad to print. Your image should be above or below the center. This will get rid of the voids in the center. I have trouble with voids on the edges as well. Try printing about 50 hits on a piece of paper. They should go away after that.
djkees123 3 years ago
HI man
Listen i made the print work it was the Plate and ink, Now Very good print. However, i noticed small bubles or dots in some areas of the print. Especially in the centre and some on outer edges - but outer little bubbles change from print to print... so could it be the pad?
What pad you suggest for pens with printing text on it. What i have right now is same pad as yours rectanglar one in this video...
thx man
johnlazik 3 years ago
Comment removed
fanofheadroom1 1 year ago