Wow that is some serious stick-out you have on that electrode.
valveman12 7 months ago
@valveman12 gas lenses rule.
rongpockle 7 months ago
@rongpockle Ah I see! You would need a gas lens to get into those tight corners. Thank you for the reply. Is that a #6 cup?
valveman12 6 months ago
What material and size/thickness do you use for the frame?
JustWonderingHowToDo 7 months ago
@JustWonderingHowToDo Mainframe is 1.75" in 1.2 and 1.6mm wall. Other tubes down to 0.9mm wall
@rongpockle so a large thin tube is to save weight I assume,I'm guessing the recumbent must flex a little,so its all a give and take in design.thanks to whoever posted this.
inagod 6 months ago
really nice quality work, wish i had access to that equipment . my trike should be ready for a test run tomorrow check my channel
sweeney37 9 months ago
purrdy
runxner 9 months ago
Wow that is some serious stick-out you have on that electrode.
valveman12 7 months ago
@valveman12 gas lenses rule.
rongpockle 7 months ago
@rongpockle Ah I see! You would need a gas lens to get into those tight corners. Thank you for the reply. Is that a #6 cup?
valveman12 6 months ago
What material and size/thickness do you use for the frame?
JustWonderingHowToDo 7 months ago
@JustWonderingHowToDo Mainframe is 1.75" in 1.2 and 1.6mm wall. Other tubes down to 0.9mm wall
rongpockle 7 months ago
@rongpockle so a large thin tube is to save weight I assume,I'm guessing the recumbent must flex a little,so its all a give and take in design.thanks to whoever posted this.
inagod 6 months ago
really nice quality work, wish i had access to that equipment . my trike should be ready for a test run tomorrow check my channel
sweeney37 9 months ago
purrdy
runxner 9 months ago