Sire Custom Performance Dual V8 engine coupler (Close up part 1)

[lejink]

you should have done build videos..you would have had a shit ton of subscribers

[kingofnone]

what are the two block base sizes?

[SireCustoms]

@kingofnone 350 cu

[PHILACEDESIGN]

@SireCustoms where did u get the coupler? wat is it from? I have found a few but nothing as stout?

[advancedtomorrow]

what's the cost of building such a car? (i mean engines, tires, chassis, all other parts, working hours, etc.).

[SireCustoms]

@advancedtomorrow i put 12k plus parts i had..probably around 30k? and from start to the state its in now 240 hours labor

[olevixx]

looks just like the driveshaft dampener on my Mercedes :) Nice!

[RESET1776]

Just wondering, do you use a single high output starter on one engine being it's basically one crank when connected? 

[SireCustoms]

@RESET1776 thanks for asking, i use 2 just to make things easier on parts and in case one goes out..... this thing is a BIG experiment..lol

[LVL60Beltran]

So the rubber center piece provides cushioning, correct?

[SireCustoms]

@LVL60Beltran yes it does!

[morbitron6]

Wow man. Thanks so much for posting this. Nothing cooler then great engineering and you guys are absolute monsters. Great car man. Thanks again for sharing!

[trxspirit]

you seem tired

[SireCustoms]

@trxspirit haha.. i am

[ericbhunt]

@SireCustoms come on the next set of motors has gotta be an lsx set up right that would so kick ass to the moon

[SireCustoms]

@ericbhunt Sure if you want to supply them, and i"ll quad turbo them!

[SireCustoms]

@ericbhunt Sure if you want to supply them, and i"ll quad turbo them!

[daddyoca69]

are you only keeping the front flywheel to balance the crank shaft?