TT-01 brushless

[tanamus13]

How did you fit an 8 cell battery in there? Got pics?

[INFAMOUSALITY]

Once again, people want to put a brushless set up on there TT-01's but not add weight. There are small weights you can put on the car to stabilize the power to weight ratio. Another thing, those Vintage tires are shit for that power. Throw some Nitro Shoes on it. Even some TC3 Factory Team adjustable shocks. Sure as hell will be better than what your running.

[jakeze808]

is that the drift version? because t=it seems to be sliding every where

[RangerPate]

The tires were hpi vintage touring rubber ones.

The reason it drifts is because it has way too much power.

The car was drift version out of the box, not any more

[Iameveryone1011]

what's a brushless? i'm asking this question because I don't own an rc car.I'm building one from scratch including the remote.

[RangerPate]

Brushless motors dont have brushes :) the can has windings and the shaft has magnets.

They are low maintenance and very powerful.

This tt had over 1hp.

Just google it for more info.

and the 8 cell fit nicely in using humpback pack and custom battery bar.

[james1772]

How the heck did you fit an 8 cell battery in this chassis?

[pinoyeh]

The car don't have enough traction to put the power of the motor on the road. Use a softer compound tire on the rears.

[snapywrist]

my dad wouldnt have the money for that, very higher tech than a plain

[ab61373]

hi! im getting a sidewinder 5700kv is it good?

[RangerPate]

both will be good. 4600 is great at drifting, 5700 is better for high speed runs. You will get longer run times with lower kv and the motor stays cooler too.

[chunkyfunkymonkey28]

Thanks, looks like I'll be getting the 5700 hopefully

[chunkyfunkymonkey28]

should I put the 4600 or the 5700 in my TT-01?

[harjunLFS]

if you want more speed get different gears and a Li-Po battery with alu parts

[RangerPate]

Stock gears, mamba is on my ifs-r atm.

[avbg2000]

im runnin a mm7700 in my tt01... definitely overpowered. i cant get it up to top speed. it always starts to slip out at the rear like this one

[supra0707]

whats the gearing you use for this brushless motor?

[Hongnormutilator]

A little bit overpowered:-)