kjw ruger mk1

[cmhsd619]

i just bot one of these i hope it is good

[FPS5000Airsoft]

is this polymer

[xxxBradTxxx]

@FPS5000Airsoft 100% metal it's only $49.99 at airsoftmegastore

[ilurvllamas]

anyone know if the we p08 luger magazine would fit in this pistol?

[fedexmoviesexspress1]

ive heard the trigger is 2 tough 2 b comfortable what do u think?

[LYUDCOLEGA]

I want to buy the same !! Can you tell this gun a good choice and how many magazines can shoot with one introducing of Gas !?

[phrawgg2]

the only thing that seems to suck about it is the mag release. it makes even less sense than the mag release on a luger

[Eiriikk111]

that gun fucking hurt !

[emeraldslothproducts]

can you remove the front sight?

[hebeya10]

@emeraldslothproducts yes



[emeraldslothproducts]

@hebeya10 thanks man, that helps me out. now to just get the thing ordered f*@#%&!

[1MrPink1]

I have the same gun Its GREAT!!!!! Think of buying it

[kingtut521]

this gun i have gotten up to 414.2 fps on this gun. not a good close range weapon, but if you using it from atleast 20-30 feet, you can fight off a good amount of enemies.

[CmoreBuhts]

What's the fps with .12 bbs?

[ninja067]

@CmoreBuhts don't use .12 bb, they'll mess your gun up

[BLARG0868]

Wont red gas tear apart a little plastic gun lik this?

[hebeya10]

@BLARG0868 internals are all metal and this is a very high quality nbb

[MegaHunter24]

@hebeya10 hey i like ur vid i suscribed and im jw is this gun a good buy because i was thinkin of getting it, and im jw how long do u have to hold the green gas in the valve and how many clips can u use in one fill up

[jjman337]

I bought this gun and the first time i used it the clip leaked.

[THEPYROGUY13]

well you need to tighten your valve screw

[jjman337]

@THEPYROGUY13 Do you mean the hex screw on the back of the mag? I wouldn't know how to tighten the valves because the piece of crap manual was written in Japanese.

[THEPYROGUY13]

@jjman337 yes that is you should tighten by going clockwise but don't over tighten it. fill the mag with gas and then slowly tighten it till it stops leaking

[hebeya10]

the difference between a blow back gun and a non blow back is that a blowback gun whenthe trigger is pulled a hammer hits the valve on the mag and releases gas into the blowback chamber and thus propels the bb and there is a special valve so once the bb is fired the chamber expands pushing the slide back. A non blowback when pulling the triggger it pulls the barrel back into the mag(like in the video) and then the hammer strikes the gas valve on the mag.

[drunkgoat46]

nice. im think of getting it, but i have a few questions.

1) what the diffrence between non blow back and blow back gun?

2) how does the gas work? do you just shoot it up that hole in the clip, and how do you know when its full?

[hebeya10]

You will know when the gas is done when you do not hear any liquid gas or propane filling in the mag. And blowback guns are less accurate and less fps