King Pin Fitting on the Sunnen Hone

[theycallmeGIORGIO]

hahaha..best part of video. 0:07

[par4par72]

I'm sorry, But did he just say that reaming it would vary by .002-.003 T.I.R?...He must be out of GD Mind!

[watcbd]

Wow, he can tell by feel. A human micrometer.

[dashwood123]

Good one, it is nice to see a job done properly.

[nartfocker]

Brings back some nightmares, John: 8 hrs a day on a Sunnen MBB-1650 (manual feed). At one point, I had that damm machine's serial number memorized ......

[jacktheripped]

I hope he doesn't plan to drive this car too much. Spindels are among the worse things to Chrome plate due to Hydrogen Embrittlement. Due to the stress that a spindle gets they break easily.

[chickeneggs4u]

My dad was a kingpin. He liked kingfish. King me. I learned something today,thanks John.

[nolatoolguy]

u sure are right..............few cars use kingpins.......i was talkin to a mechinic about what u dont see used anymore an i like all the kingpins an he gos huh....

[MrKhalio]

nice job,but if there is any un balanced pressure by your hand u will get misalignment,why u using manual method ???

thanks

[gst69man]

very impressive machine shop

Congrats.

[zapwatt]

John, is that a Deltronic pin you were using to check the bore I.D ?

[1SICKYJ]

Kool thanks John great work as usual keep it up.

[ls6guy]

sweet great work

[masterd151]

haha nice face shot at the beginning.