@DJelectfire All I did was disconnect all the wires from the CRT and connect them to 2 diffrent DPDT switches, one for the vert and one for the hoz, so I could switch between the 2, on the hoz I added a 30 ohm res to the point on the circuitboard where the 2 wires for the hoz signal comes out, to keep the screen from going black when all the wires were disconnected from the CRT
cool
HLPHRS 6 months ago
Well done! Better than the one I did a few years back! How did you get to display a dot instead of a bar?
DJelectfire 6 months ago
@DJelectfire All I did was disconnect all the wires from the CRT and connect them to 2 diffrent DPDT switches, one for the vert and one for the hoz, so I could switch between the 2, on the hoz I added a 30 ohm res to the point on the circuitboard where the 2 wires for the hoz signal comes out, to keep the screen from going black when all the wires were disconnected from the CRT
cultfusion1 6 months ago