this would run if coupled with generator say 3kw, bring the speed to 400rpm then install the required sheave to reach the generator required speed of 1800rpm, no need for variable speed motor, to vary the speed adjust the meshing of drive motor when it reaches its speed-- SIMPLE, SHARE TO EVERY BODY
Saw that vid, it proves nada. Simply because to be credible you need at least 4 runs, two same car on same track, two with switched over cars. Those things don't all perform alike. This doesn't mean I'm saying that the result isn't possible, just that the vid is no good.
Sure, when I was a kid I had a little yellow track for matchbox cars and before the loop de loop there were two foam coated wheels power rortating, powered by battery. When the car entered between the wheels, it got ejected with enough velocity to make a complete tour of the circuit, then re-enter the accelerator wheels.
Your calculations are not correct! Place the generator at 2kw and try to run your system. But you do not do and it shows that the system does not work.
@zxinvest you could easily find all Calculations made by Dr.Kanarev especially since you speak Russian ZXinvest...but i guess you didn't bother or simply that was not the point of your comments anyway. was it?
Νικος ... Συνεπως Οσο μεγαλυτερη ενεργεια ζηταμε απο το συστημα τοσο το συστημα θα επιβραδυνει , Τελικα θα βαζουμε μεγαλυτερη ενεργεια στα drive απο αυτην που περνουμε στον αξονα..
Νικος.. Το προβλημα εδω ειναι οτι ενω οι υπολογισμοι για την κεντρομολο φαινονται σωστοι, εντουτοις ειναι για ενα συστημα χωρις φορτιο στο κεντρο του αξονα ..
Για να δουμε αν το συστημα παραγει κατι παραπανω θα πρεπει να βαλουμε ενα alternator πχ . 1 Χ 10 και φορτιο στο alternator πχ 500 - 1000 WATT . Η γνωμη μου ειναι οτι με το που ενωσουμε το φορτιο το συστημα θα αρχισει να επιβραδυνει.
αρα θα χρειαστουμε μεγαλυτερη ενεργεια στα drive για να συντηρησουμε τιις στροφες του συστηματος .
True Free energy devices exist,But Millions are spend in supressing that information,Go to LT-MAGNET-MOTORdotCOM and get the blueprints for a genuine magnet motor ,Let the revolution begin!
the difference to a flying dutchman on a fun-fair, is that the driver wheels, which keep the system in motion are not on ground level but rather on top, little by side.
this makes it possible for the wheel+attached weights, with an inertial push, to turn a full rotation, back into the position of the driver wheels on top, which speeds it up again.
the point, where the driver wheels are fixed, their giving the most power to the system with the lowest energy need, because gravity is already acting
Congratulations for your success! this is legendary simple..
>>THIS IS A ``ONE-WAY FLYING DUTCHMAN´´ !!,<<
what you have constructed here, in my opinion.the difference is, that it makes full rotations(not only left and right), with the weights attached to it and the little help of the driver motors on the top.
this is exactly, what many people know from (county/state) fun-fair's.
i took often a ride witch such a thing, and it directly reminds me of this system, shown here in this video.
Mr Chalkalis, have you ever try to get power out of that wheel? For example, how about putting a generator on the same shaft and to see if the machine will power itself?
Yes, it's true that energy builds up when wheel is gets going by the power of centrifugal force, but "my question is" will it continue to go under same speed under load?
Dear “fellow human” as Mr.Chalkalis have called you,
you can find all data and plans of the device on his Blog. Also you could google it and see how SERIOUS people are using the forums to discuss their opinions. I see you are Australian so I would suggest you to go at energeticforum(dot)com
It really makes me sad that people like you can judge without even bothering to look at the details. Unless of course you have some other objectives behind your comments.
4me great invention 4ever...
EnergyColec2rGravity 2 weeks ago
this would run if coupled with generator say 3kw, bring the speed to 400rpm then install the required sheave to reach the generator required speed of 1800rpm, no need for variable speed motor, to vary the speed adjust the meshing of drive motor when it reaches its speed-- SIMPLE, SHARE TO EVERY BODY
uying99 1 month ago
Saw that vid, it proves nada. Simply because to be credible you need at least 4 runs, two same car on same track, two with switched over cars. Those things don't all perform alike. This doesn't mean I'm saying that the result isn't possible, just that the vid is no good.
nicbordeaux 3 months ago
Sure, when I was a kid I had a little yellow track for matchbox cars and before the loop de loop there were two foam coated wheels power rortating, powered by battery. When the car entered between the wheels, it got ejected with enough velocity to make a complete tour of the circuit, then re-enter the accelerator wheels.
nicbordeaux 3 months ago
@nicbordeaux
Since you like it in "Machbox Cars" ;) search for "High Road Low Road Race" video!
W32DEFENDER 3 months ago
what you say on this ..... free energy or the physics "youtube.com/watch?v=IRwIda7Wz3k." Place the generator at 2Kw and try to run.....
zxinvest 4 months ago
@zxinvest
Dear Zinvest, I saw your video and I have to say that it really shows your genius way of thinking!!!
W32DEFENDER 4 months ago in playlist Περισσότερα βίντεο από τον χρήστη CHALKALIS
Comment removed
zxinvest 4 months ago
Your calculations are not correct! Place the generator at 2kw and try to run your system. But you do not do and it shows that the system does not work.
zxinvest 4 months ago
@zxinvest you could easily find all Calculations made by Dr.Kanarev especially since you speak Russian ZXinvest...but i guess you didn't bother or simply that was not the point of your comments anyway. was it?
W32DEFENDER 4 months ago
you are right,theres no doubt that the feltenberger pendulum pump uses the same working priciple! youtube.com/watch?v=yheVAF-Zrvo
for me its the 110% proof of your system, no question!
neuberlintourist 5 months ago
Why no more vids
Jhfgsjdcd 5 months ago
Comment removed
MorskoyZmey 8 months ago
Doctor Kanarev does the mathematics on FM Chalkalis device...
CHILLOUT2HEAR 9 months ago
Νικος ... Συνεπως Οσο μεγαλυτερη ενεργεια ζηταμε απο το συστημα τοσο το συστημα θα επιβραδυνει , Τελικα θα βαζουμε μεγαλυτερη ενεργεια στα drive απο αυτην που περνουμε στον αξονα..
nikos0074a 1 year ago
Νικος.. Το προβλημα εδω ειναι οτι ενω οι υπολογισμοι για την κεντρομολο φαινονται σωστοι, εντουτοις ειναι για ενα συστημα χωρις φορτιο στο κεντρο του αξονα ..
Για να δουμε αν το συστημα παραγει κατι παραπανω θα πρεπει να βαλουμε ενα alternator πχ . 1 Χ 10 και φορτιο στο alternator πχ 500 - 1000 WATT . Η γνωμη μου ειναι οτι με το που ενωσουμε το φορτιο το συστημα θα αρχισει να επιβραδυνει.
αρα θα χρειαστουμε μεγαλυτερη ενεργεια στα drive για να συντηρησουμε τιις στροφες του συστηματος .
nikos0074a 1 year ago
This has been flagged as spam show
True Free energy devices exist,But Millions are spend in supressing that information,Go to LT-MAGNET-MOTORdotCOM and get the blueprints for a genuine magnet motor ,Let the revolution begin!
perplexfraction 1 year ago
please give a data for the energy input for the two driver motors on top in watts
thanks
neuberlintourist 1 year ago
the difference to a flying dutchman on a fun-fair, is that the driver wheels, which keep the system in motion are not on ground level but rather on top, little by side.
this makes it possible for the wheel+attached weights, with an inertial push, to turn a full rotation, back into the position of the driver wheels on top, which speeds it up again.
the point, where the driver wheels are fixed, their giving the most power to the system with the lowest energy need, because gravity is already acting
neuberlintourist 1 year ago
Congratulations for your success! this is legendary simple..
>>THIS IS A ``ONE-WAY FLYING DUTCHMAN´´ !!,<<
what you have constructed here, in my opinion.the difference is, that it makes full rotations(not only left and right), with the weights attached to it and the little help of the driver motors on the top.
this is exactly, what many people know from (county/state) fun-fair's.
i took often a ride witch such a thing, and it directly reminds me of this system, shown here in this video.
neuberlintourist 1 year ago
Mr Chalkalis, have you ever try to get power out of that wheel? For example, how about putting a generator on the same shaft and to see if the machine will power itself?
Yes, it's true that energy builds up when wheel is gets going by the power of centrifugal force, but "my question is" will it continue to go under same speed under load?
You need to test this.
mksboysal 1 year ago
Dear “fellow human” as Mr.Chalkalis have called you,
you can find all data and plans of the device on his Blog. Also you could google it and see how SERIOUS people are using the forums to discuss their opinions. I see you are Australian so I would suggest you to go at energeticforum(dot)com
It really makes me sad that people like you can judge without even bothering to look at the details. Unless of course you have some other objectives behind your comments.
LUPOHACK 1 year ago
HOPEFULLY THE WORLD WILL CHANGE SOME DAY..!!!
LUPOHACK 1 year ago