Squaring panels with the ez smart track saw system.

[ilivensoca]

I would like to see at cross corner measurement check to see if the panel is really square. I think that you would fine a progressive error factor by the time you get to the third cut and the panel would not be parallel or square.

[buickwildcat1]

excelent demonstation of this system capabilities

[BradburyGuy]

You cut two straight lines but I didn't see you square the corner.

[crustycrayon]

Because the second cut was made off of the first cut, that corner would be square.

[ardvarkkkkk]

@crustycrayon Only if the jig was square. If it's not, none of the cuts will be either.

[tonyshit80]

Yes, I have the bosch circular saw, I dont see how can I get it the aluminium fence. and it is fit to used with my circular saw..pls...I,m fom Malaysia..

[ionxi]

what is that aluminum fence called? is it universal for all circular saws models? many thanks for sharing your knowledge.

[kmkmkm1959]

Ez Smart Guide system. Made in USA by Eurekazone.

[musicpar]

very clever