#4 Banyan's HHO Dry Cell, How it's made!

[SINCLAIRRESEARCH]

Its good idea ! but id say much better if the plates were rigid , excellent idea with the tape for seperation , ew also found that 1/16 was a perfect size to use between plates as then the bubbles can actually get out . like your ingenuity though .

keith sinclair

[kdkinen]

i don't know how you made the foil work. i thought it would have just turned into an arcing disaster.

[mowerman54]

I currently have a smack design booster, and can't seem to get the production from it. What would the expected production from a dry cell such as yours?

[Banyan23]

Production is one thing. I like to compare my results in MMW. Gas production will depend on how much heat (Amps) your cell can take without melting, meaning how much electrolyte you put in your cell. The smack design is great but there is way too much volt leakage and give around 3.4 mmw which is average for a wet cell. Dry cell in general will give you 5 mmw and more, 7 been 100% efficiency. My cell gives me 5.4 mmw.

[duenschman]

so, you would say that your disign is more efficient than the smak?

I can see much ammounts of current leakage between the holes in your plates.

[duenschman]

good idea, very cheap.

[LAI8781]

請問影片中的是鋁片還是銅片？或者是其他材質

[asidburn07]

only use stainless steel

[jansan2007]

Excelente trabajo ,Thank you inspire me to improve my design and make my Dry Cell

the tape you use, is the rubber, which is common to use electric

You can give me any specification, or link, thanks

Jan San

[Banyan23]

You will find this tape in any hardware store in electric and/or pluming section. It is a 20 mil of an inch PVC tape. Use tow layer of it between the plates. That's all I can say so far! Hoppe it helps.

[quehueveo]

where do you get the ss foil? great idea.

[Banyan23]

Thank you!

[villenbruc]

Banyan, Nice job !! Excellent low cost design.  Keep up the good work !!