Vw Water Pump Replacement - How To Prepare The Gasket Surface Area

[notoriouslizw]

Two questions: what's the torque on the bolts and should anti-seize or Loctite or nothing be used on the bolts?

[TheFuckinandy]

this is by far the most helpful video i've watched!! i was actually searching for a how to related to the amount of permatex to use so that i wouldn't make the same mistake for the third time. thank you for your info.

[TheFuckinandy]

this is by far the most helpful video i've watched!! i was actually searching for a how to related to the amount of permatex to use so that i wouldn't make the same mistake for the third time. thank you for your info.

[TheFuckinandy]

this is by far the most helpful video i've watched!! i was actually searching for a how to related to the amount of permatex to use so that i wouldn't make the same mistake for the third time. thank you for your info.

[Liamautomechanic]

good video,

[Comrad132]

finally some smart advice that surface preparation is key in all seals

[SuchAssholes]

Hi... Great Video, I'm sure you've helped a lot of people. One thing though, is this for a new or old Beetle? Thanks.

[blauparts]

This was filmed on a 2.7T Allroad. If you have a flat metal surface, prepare it as featured in the video. If your model has only an O-ring, clean it in the same manner demonstrated in this video on the thermostat area.