This shows the wire bender in an early stage of development -- we made a few changes on the second day at unCraftivism, and increased the speed of the servo. We also make an almost-circle by reducing the feed length to about 5mm and the bend angle to just a few degrees.
The Hypnotoad!
NotJames1 7 months ago
which software you use to generate g code?
pawlinoliveira 1 year ago
GCode for which project ?
jarkman01 1 year ago
This has been flagged as spam show
which software you use to generate g code?
joice588 1 year ago
which software you use to generate g code?
joice588 1 year ago
hell of a way to use a shopping cart wheel lol
engineering216 2 years ago
Great one!
pamelawoods1 2 years ago
This shows the wire bender in an early stage of development -- we made a few changes on the second day at unCraftivism, and increased the speed of the servo. We also make an almost-circle by reducing the feed length to about 5mm and the bend angle to just a few degrees.
anachrocomputer 2 years ago
Hypnotoad Lulz
GunSotsOverMe 2 years ago
Great !!!!!!
arielchico 2 years ago