2007 Civic Si Sedan emblem

[Peratius]

yes it does have 2 screws use a flathead lol

[claskils]

use dental floss for the double stick tape portion and remove the left over adhesive with a eraser wheel but on the back of the emblem has location pins so ull have to get them welded

[Transformerxxxxfag]

you guys are dumb ass, there are rings attached to the back of the emblem

[evoarny8]

just pop it out from the inside

[imixxmedia]

just use floss and then use a little force with your finger to pop it out

[sparbaroku]

You are definitely a northerner!

[carfreak59750]

@sparbaroku good call! you can read the license plate!

[sparbaroku]

@carfreak59750 LOL I guess that too but I was talking about your hardcore accent.

[Rjelperuano7]

jst use ur fingers n grip it out..dem type of honda logos come on & off easy

[pmcmasterfunk21]

Well I have a feeling you have gotten it off by now, but I used strog braided fishing line. Slide it under the emblem and do a cutting motion with the fishing line. When you just to the two little nipples jut break it off (unless you want to salvage)

[BmXKingsLynn]

Use a flat screw driver :DDDDDDDD

[cbcarter0]

You should get a JDM honda emblem for the front.

[SRdrummer]

it just pops off...take some dental floss...floss the back of the sides, then pop it off...gotta get it touched up after that cus u will be left with holes.

[souljadeez]

in back im pretty sure there arent screws, you want to heat up the emblem and then take some fishing line and put the fishing line behind the emblem and scrape as close to the body as possible then you remove the adhesive with adhesive remover but if its screwed on which i doubt it is your shit out of luck DONT PEEL IT OFF it will chip ur paint

[reillys89]

dont u will be left wit 2 holes in where the H was

[uno787]

pull up with finger nails on emblem

[06TurboVtec]

its held down by two pin clip things, just do the same thing u did for the civic badge, but u will have to then pry it off with some force and it should pop off

[tpsonak]

it just pops off.

[AndyRoddick969]

haha, actually if u havent already, i made a video on taking the front and back emblems off and replacing it with new Type R emblems.

[st3nkobe]

my spec v will fuck that easy

[potchi27]

how do i remove the front one..i hava a O7 si i wanna replace it with a red jdm emblem

[AndyRoddick969]

i have a video up on my channel removing the rear honda emblem. im for sure it will help you out!

[bBoYPhiPhi]

Beautiful color bro

[wrxpower123]

rip it off with a flat head scwer driver

[seanmcmills]

I am always amazed at the amount of misinformation regarding removing the Honda "H" emblem. So many replies say it's as easy as using a blow dryer, but they don't realize that the Honda "H" is not merely held on by glue, unlike the "Civic" and "EX" etc emblems. You are right. There are two "pin clips" that hold on the Honda "H" that will leave two holes in your trunk. Someone else told me these are called pin clips. I guess we both need to consult a body shop.

[ProDiffer]

no screws just really sticky pads heat them up with a heat gun and use dental floss to cut the padd off then rub it with a cloth and polish it!

[karissa609]

if its like the civic i had the rear emblem is held on by glue and 2 pegs that are in the 2 holes in the trunk... I personaly wouldnt take it off unless you are going to bondo the wholes or replace it... because on something that new it would be kind of tacky having the hole in your trunk...IMO

[marcmazz]

i did the same thing to my 08 si coupe..

the rear is easy..

-use a blow dryer to heat it up until the emblem is hot to the touch

-use fishing wire, or (teeth) floss and slowly work ur way down, you right there are two little pins holding it in..

-once u work ur way aroudn the emblem use ur finger nails and once u get a hold of it, it should pop off with out a problem.

im doing mine right now actually,and having problems taking the front emblem off. if anyone knows that would be great help.

[AndyRoddick969]

yea the front one you have to get under the hood and remove a couple parts. search College Hills honda and u will find a vdieo of them removing the front emblem.

[718labrea]

You should ask a youtube user: murderedoutcivic he is helpful to fellow si drivers

[johnpark219]

i have the same Si Sedan bud.. all you need is BLOWDRYER just hold it up close to it for like a minutes and start pealing it off gently. there are two holes that place that emblem but once that tape is hot enough to come off that will easily come off as well.. front is little harder but its same method.. use blowdryer and do that same for the front.. the tips might break but thats fine cause Red JDM will stick really easily if you are going to get them.. i did..

[LiLspikeeepnoy]

Ummmm just replace the old honda emblem and put some RED honda JDM Emblem. Would look alot better.

[levi99]

i have one just like that! awesome car

[flipkid87cs]

go to 8thcivicdotcom It has everything you want to do to your Si.

[titenate]

check underneath the liner on the trunk lid.