While the operator's feed rate has an effect on the depth of cut, the response time of the safety system is under five milliseconds. In short, a faster feed rate may make a slightly deeper scratch, but the difference should not be very obvious. We are always conscious of supporting safe cutting practices, and are careful to demonstrate commonly-recommended cutting speeds in our videos. Other older videos found on YouTube often show a faster feed rate, with the same positive result.
who has the blade that high
bryanistenes 1 week ago in playlist Hotdog Demonstration
While the operator's feed rate has an effect on the depth of cut, the response time of the safety system is under five milliseconds. In short, a faster feed rate may make a slightly deeper scratch, but the difference should not be very obvious. We are always conscious of supporting safe cutting practices, and are careful to demonstrate commonly-recommended cutting speeds in our videos. Other older videos found on YouTube often show a faster feed rate, with the same positive result.
sawstop 9 months ago
The guy was moving the hot dog rather slowly. What would happen if he were moving it faster, like he would in real life?
tunghoy 9 months ago
@tunghoy Actually that looked like a reasonable speed to me, though I wouldn't doubt many other people would move faster than that.
samuseternal 9 months ago
I definetly like this. Gotta get myself one of these!
woodentoolcompany 9 months ago