Added: 1 year ago
From: Spencerian
Views: 13,929
Sort by time | Sort by thread (beta)

Link to this comment:

Share to:

All Comments (75)

Sign In or Sign Up now to post a comment!
  • dont forget to twist the plug once you insert it, that way when you pull the plug inserter out the plug will stay seated well because of the knot created. It will also not pull out then.

  • @Revilingfool That's an awesome tip. I didn't know that. Thanks for contributing to the knowledge base. I'm sure that's going to benefit lots of folks.

  • Comment removed

  • chicken dance in the middle was the highlight for me

  • Those kits often come with what looks like patches with a sticky backing, yet I’ve never seen anyone use those, what are they really for?

  • Hang-on, if you threaded the plug THROUGH the needle, how come it didn't come out when you withdrew the needle?

  • Vulcanization? Is that when everyone is turned into a Spock?

  • My dealer helped me put in a plug the first time and it lasted for the remaining life of the tire. I'm not going over 50.

  • it looked like a cotter key

  • @breethwithme Yeah it was. I guess I just happened to roll over it at the wrong angle.

  • Plugs should only be used to get you to a shop than can install a patch inside the tire.

  • @VVoodstockRider well I came across a situation that I had to use one.. it only lasted a short time before leaking.. I put a new one in and in a day it failed again... I guess each tire is different.

  • first i enjoyed chicken aloha dance, second i need to get tire repair kit and third instead of trimming the ends could i burn it down , iv seen people done this on car tires??

  • @DucatiS2R1000S haha... you like the chicken dance, eh? As far as burning the ends down, I don't see why you can't do it... but trimming is does what you need to do. Also, the rubber cement activates the vulcanization process, so it's a chemical melting/fusing thing that occurs in the rubber. I suppose if you didn't have the rubber cement, burning could be a way to go to completely seal the tire.

  • where in hawaii do you live??

    i visit maui all the time and love the east side of the island

    its beautiful

    but great vid man

    im 14 and freaked when i foumd a nail in my dirtbike tire

    thanks for the help

  • @loopyboopoo1 I'm on oahu. Yeah, the patch saves the tire until you get a new one.

  • Got a flat on my bike now. Gonna give this a try.

  • What a bunch of newbies. You NEVER plug a bike tire unless you are only going to the dealer or shop to have a new tire put on or you ride like an old man on a scooter.

    Anybody who knows anything about riding knows this.

    DO NOT TAKE THIS GUYS ADVICE HE IS DIRECTING YOU TO DO SOMETHING COMPLETELY UNSAFE ESPECIALY ON A SPORT BIKE, ARE YOU KIDDING ME

    DONT BOTHER TALKING SHIT EITHER IVE BEEN RIDING FOR OVER 25 YEARS ALL 25 ON SPORT BIKES. EXPERIENCE IS KNOWLEDGE.

  • @TONY22407 Spoken like a dealer. Sometimes motorcycle tires can be repaired, just like car tires. Yeah, talk to any dealer and its oh yeah, you gotta get a new tire. Unless you're a noob, then "you should get a new bike". I've know people to have ridden with plugged tires. Patching might also be an option once you get home.

  • @dahveed284

    Yes im sure you can get some mileage out of a plug or patch BUT is it safe at high speeds the answer is NO, most plug packages will even tell you not to exceed a speed of 50mph, good luck doing that on a sport bike or on any bike for that matter. By the way comparing cars to bikes, dude come on

    I guess it all depends on ride style, experience & maturity.

    Do this, next time when your on the highway passing someone, think about that plug in your tire, how safe do you feel now?

  • @TONY22407 Well, if my plug fails, the air is going to leak out of the hole. It took the tire 5 or more minutes to lose all the air when I pulled the nail out of it, so its hard to believe that a plug failure is going to cause a sudden tire failure. Maybe it will leak, but I don't see that as a big safety factor.

    I would have gladly removed the wheel and taken the whole thing down to a shop to have the tire patched professionally from the inside. But nobody will do that.

  • @dahveed284

    Ok let me break it down for you, the fact that there's a plug in there is not the problem its that the tire has a hole and that hole is a weak spot in the tire now. The tire has lost structural integrity and at high speed can BLOW APART at that holes location.

    All that plug does is hold the air in, thats it, it doesn't repair the tire as a whole.

    Who knows how many metal braids were damaged by the foreign object. That tire is now subject to disaster. THATS A BIG GAMBLE.

  • @dahveed284

    Why wont the dealer patch it? Because the dealer does not want to be responsible for that tire now because it is now unsafe, a risk and a liability.

    Yes the dealer gets to make money now because of a safety factor, a legitimate safety factor. Cant expect the dealer to give tires away for free.

    Patching a car is one thing but a bike is not cool.

  • Good video, but I really gotta say that a plugged tire is a risk. If you wanna take it, that's your choice.

    (I work as a mechanic, so I deal with tires all the damn time, and I keep a plug kit in each of my bikes. Plugging is fine to get to a shop, but I really can't advise this as a long-term solution.)

  • I just got a nail in my motorcycle tire, and there is only 500km on that tire so I don't want to throw it out.. basically the same place in a tread groove.. people told me never to use these kits on a motorcycle tire but after doing research and watching video's like this, I'm about to get one of these kits and repair it myself.

    Thanks.

  • I got a nail in my rear tire right about in the same spot a month ago, And i ended up getting that same kit from walmart lol

  • Useful!

  • Haha I see I'm not the only one focused on the knife...

    The knife was the WHOLE VIDEO!! :D

    P.S. Believe it or not, there's people out there that "trim down" screws and nails so it punctures, and pops out. I caught a couple of them (that didn't pop out), and when I pull it out, you can see they were ground-down to a "short point".

  • Haha I guess I'm not the only one focused on the knife...

    The "knife" was the WHOLE VIDEO!!! :D

  • Wierd coincidences. I hear a siren outside and it passes by. I sit back down and hear another siren. I think... why's it coming back?

    Good stuff to know. Fingers crossed. Hope to never need to use it.

  • LOL. Love the chicken dance.

  • I feel like i should keep one of these on my bike somewhere. Just in case.

  • Thanks for the vid and for picking up the sharp thingy, and also for the (highly illogical but strangely provocative) Hawaiian chicken Vulcanization dance. The drummer is a musical genius, btw. :)

  • 2:22 That critter's gonna give me nightmares :/

  • Comment removed

  • great vid :) having a flat tyre 50km from home is no fun at all :( since then I carry a repair kit, compressor and a jump starter I use for 12V supply, and of course since i've been doing that, no punctures! pffft! :D

  • That is a cool-looking knife!

  • wow!!! nice video gotta get me one of those..

  • Nice demo. I really need to get a plug kit. Did you have an air can or pump to put air back into the tire?

    Like the automatic knife. Nice short blade. Looks like it could be a key fob!

  • @Fudmottin It's the Kershaw Leek Rainbow. It's not automatic, but it does have a lever to push & flick out the blade.

  • Thanks for the sharing.

    Actually, I always carry exactly same plug-kit at the saddle bag.. ha ha ha

    I now know how to use it..

    Thanks.

  • Comment removed

  • good info n cool knife,look like it got kameleon paint on it

  • @SuperTrav26 It's a coating called Titanium Dioxide. It's supposed to be black, but if taken out of the furnace prematurely, it reacts differently with the air and becomes colorful.  The coating is exceptionally hard & scratch resistant.

  • Nice. When I got a hole in my tire, it was in the middle, so when I plugged it like you did, it didn't last much longer than 20 miles before I had to stop and replug it again.

  • @ToastToGo You have to trim it in such a way so that it's flush, and doesn't pull out. Also, you need to use rubber cement, so that the rubber vulcanizes and closes the hole up. I forgot to add that you need to ride the bike, so that the plug spreads out on the inside of the tire and helps seal it.

  • Thanks for sharing!

    That's some mighty good keychain there.

  • so how well do these hold up over time. last year I "had" to replace my rear tire 2 times because they (the shop) told me that you should not plug a motorcycle tire.. how accurate it that?

  • @kary1982v6 Plugs work fine, I wouldn't do track days on a plug but for the street they hold up well. Moto shops generally will not install plugs on moto due to insurance and state laws. I've used the tar (ie this vid) and the plug/patch combo style used in tire shops. Inside the tire is a patch with a rubber plug you pull through the nail hole and seals everything nice and tight.

  • yep.... Im pretty sure thats my old bike. Its a bad luck bike! I'm warning you

  • @mrsfacebookgirl Were you the one that sold me the bike?

  • I see you have a switchblade.  Are you a Hell's Angel?

    I use plugs too, especially if the tire is new.

  • @cashstore1 you gotta protect yourself in hawaii, seriously.

    never know when your gonna get jumped.

  • @cashstore1 I know it looks like a switchblade, but it's not. It's actuated by a flick of my index finger.

  • @cashstore1 Darn, I thought you were a real tough, evil, nasty, bad guy. LOL

    I would like to know what happened with the stolen bike thing. I wonder if the cops did their job?

  • i loved that chicken dance...i did the same thing to my car it was on the "non safe area" and i have been driving with it in my sidewall for over 20k miles....don't let them rip you off people...the plugs are great !!! this video is awesome...

  • Great how to vid.Man that chicken likes to dance.Mahalo

  • thumbs up for the hawainn chicken =)

  • Chicken Vulcanization dance?  lol

    Good vid!

  • Dancing chicken FTW ! :D

  • That's a broken split pin use for keep nut in place.

    I thought you are suppose to give it a twist after insertion, then put out?

  • Nice how-to. I've used this process countless times...too bad it won't work on tubed tires :o/

  • great vid.

  • The original tire.Thats old rubber.I wouldn't push the twisties with that.

  • Nice and easy, good video!

  • Good Job, nice and clean.

  • Yes, drop the foreign object down to the ground next to the tire..Awesome thinking there.

    These plug kits work well.. Nice video.And your suppose to have an inch on onse side and 2 on the osterside of pluger so one bit stays inside and the other is sticking out so basicly u have the plug coming threw the hole as the foreign object was..U did it bit wrong here, hope it doesnt leak air..Good luck.

  • @Brainiac83 Yeah, the staple blew off my finger, but I did pick it up and make sure I didn't leave it there to find another tire. You're right about going too far in. With the motorcycle tire, the insert/plug usually pulls out about 1/2 inch when pulling the insertion tool out. But this time, the tool pulled out without pulling the insert/plug out. As for leaving the excess on the outside, that's a big no-no for motorcycle tires. It will pull the plug completely out if you don't trim it.

  • @Spencerian No, i think he means the way you had the rubber plug on the tool. He said you're supposed to have more on one side than the other so that the rubber plug is in straight rather than folded in half.

  • awesome thanks for posting

Loading...
Alert icon
0 / 00Unsaved Playlist Return to active list
    1. Your queue is empty. Add videos to your queue using this button:
      or sign in to load a different list.
    Loading...Loading...Saving...
    • Clear all videos from this list
    • Learn more