hi mate just put a hole pedal box in mine and found the clutch pedal hard to push down ive put a uprated clutch in and was thinking it could be the uprated pressure plate what do you think or did you have the same problem
@grady1982 I just went through all that...I lowered the pin that pushes the rod into the clutch master cyl because I had to lower the cyl 6". Doing that I lost all my leverage from the pedal and couldnt push the master in with both feet standing on the pedal. make sure the ratio of pin to pivot point(the bolt is swings on) and end of pedal(where you push) ration is at least 6 to one.(if pedal is 12" to pivot and pin is 2" to p[ivot..thats 6 to 1)
hi mate just put a hole pedal box in mine and found the clutch pedal hard to push down ive put a uprated clutch in and was thinking it could be the uprated pressure plate what do you think or did you have the same problem
regards lee
grady1982 1 year ago
@grady1982 I just went through all that...I lowered the pin that pushes the rod into the clutch master cyl because I had to lower the cyl 6". Doing that I lost all my leverage from the pedal and couldnt push the master in with both feet standing on the pedal. make sure the ratio of pin to pivot point(the bolt is swings on) and end of pedal(where you push) ration is at least 6 to one.(if pedal is 12" to pivot and pin is 2" to p[ivot..thats 6 to 1)
johncartelli 1 year ago
I particularly like the way it goes in and out.......and in.........and out.....
Noel
noel383 3 years ago
that was the best bit, was it not
niall123456123456 2 years ago