Hydrogen Tap (Voltage Check Cel) 270

[nomoreballandchain]

you should have higher caps whith out the lye

[jarvis1211]

Is that water or whats your solution?

[johnaarons]

Almost all my videos now show the plates in "Distilled Water" and "LYE".. John AArons

[Peter30750]

John- I understand that you used different cells fo your Honda installation and do not have exact measurements on fule consumption. However you must have a "feel" or an observation regaring any improvement in MPG. Did you feel that the cell(s) improved your gas maillage in the Honda?

Peter

[johnaarons]

I have tested the Honda at between 3 and 5 miles per gallon improvement... but not consistent because of the computer in the car... John AArons

[jenotsuke]

So is there a way to ground the plates between pulses? Just might be something to look at. GOOD JOB!!!

[johnaarons]

interesting idea... John AArons

[heartwind321]

Loving the videos and information. However, one future videos that have prolonged shots of the voltmeter and/or other equipment can you place a clock or stop watch in the back ground to give a physical time the experiment occurs? Thanks

[johnaarons]

You are watching my lab ... work that I am doing .. I am not conserned with proving anything...John AArons

[heartwind321]

Fair Call. Another question, as I have not watched all of your videos (or read all comments)... yet.

What is the averaged production rate of hydrogen (plate number and size dependent)?

What happens when you drive and press the gas down in the Honda? A constant production of hydrogen gas versus increased demand for fuel?

How did you over come (unless it's absent) the constant pressure increase in the system with constant hydrogen production, with the electronic pulse system?

Thank you

[johnaarons]

I am putting together a device to show the output for you ... a lot of people think that is missing... give me about a day... the amount of Hydrogen has at least 4 factors .Electrolyte ,Plate Spacing , Plate Area , Voltage (amps)..John AArons

[heartwind321]

Saw 193.

I'm sorry man.

**My Bad.**

[johnaarons]

No problem .... you have a good point... I just have to find the time to do all this... as you can imagine these videos mean I stop the work and show... the time I take even though it seems small has to be made up... mostly at night. I will get a new clock... John AArons

[marthale7]

Great stuff Aaron

What you have is plates, and acid, so, a battery with the HHO. I am wondering if you started building this as a battery ( separate cells ) if you could put the cells in series if that would have another effect?

[johnaarons]

Lye is not acid.. but I understand your idea... John AArons

[BasementBen]

In my opinion, I think a lot of the voltage is from a catylytic reaction with the nickel in the stainless with the hydrogen and oxygen.

One volt is about the output of a single hydrogen fuel cell.

[johnaarons]

I believe if that was the case the voltage would stay there... but... but.. the finding here is not toward that end... this means that pulsing the system should not have any effect... the cell does not even see it... John AArons

[lostintimeBC]

just wondering r u using ur cell or any practical application at this time

[johnaarons]

That is a very interesting question... John AArons

[jeremyleefife]

John, thanks for doing this work. My brother and I made a four cell successfully. Working towards new horizons. Thanks for your inspiration. Looking forward to seeing the overunity motor linked to an Aaron's cell producing HHO, a loop effect.

[johnaarons]

Thanks for your interest... keep watching... I have a few surprises ... in my lab. John AArons

[amborski07]

Have you found a way to store the hydrogen?

[johnaarons]

The system I am working toward is "Hydrogen on Demand"... to me that is the safest way to use it.. John AArons