ArcEye 2 LED Install Step 5-6: Button and harness setup

[dunks206]

Where did you purchase this kit?

[Purplearms]

@dunks206 I made the LEDs (Arceye2). You can get these now, but sparky v3 will be available in a few weeks..

[Purplearms]

@seth20011 All of the black wires go from LEDs to sparky. And the long red/green/blue (aka RGB) cable goes to sparky (the short ones daisy chain all the LEDs together).

I didn't show how to connect to sparky in this video. But the place to plug them into sparky is labeled on the board.

[Raitokair]

will this work on a Joytron Paewang Revolution stick i want to mode mine and give it light up buttons

[Purplearms]

@Raitokair Yes it will.. only challenge is that paewang doesnt have screw terminals so you'll need to solder wires.. you can also sandwich a wire in the quick disconnect to the buttons to eliminate most of that if you hate soldering/wiring (i personally dont like that method though)

[unknownschizo]

can't wait for the next part of the mod. really hoping to get this working

[Deathofblades]

Can't wait for part 3. This tutorial will help me a noob on how to install these hard to install LED sparky PWM board and your arceye 2.

[civicsi94]

good stuff sir. another great tutorial to add to series.

-Mufasa2