@ericsanchez2005 Had 39000 miles when installed. As of now the car just reached 50k miles. Only problems that have come up are the typical piston slap noise at start-up but it goes away in less than a minute of heating up. Have not had any engine issues with the cam swap though and cam bearings were left alone.
@ericsanchez2005 Ya it was dyno tuned by precision motorsports. There are a lot of factors in deciding if you want to cam it or not. I suggest you check out ls1tech dot com and search on there for info they give good thorough advice.
@ericsanchez2005 with a cam like this.....sure.....but a big one like ms3/4 id rethink it.....motors like to grow old with there mod friends....hard to teach old dogs new tricks...but hey...you can always rebuild it forged
@kief4diamonds After I put the cam in the stock motormounts did not last much longer as well as the tranny mount. Replaced everything with prothane poly mounts and now its rock solid and puts the power down much better.
engine revs at 1:57
Brutality110 5 months ago
Might wanna tighten up that exhaust. O_o
TheMagistix 5 months ago
@TheMagistix lol ya this video was taken more than a year ago, the missing exhaust mount was replaced a long time ago.
Brutality110 5 months ago
you apparently have some left over ricer stuck on your license plate. Must of been a honda owner.
ladygodia 6 months ago
How many miles did you have on the car when you did this Cam upgrade...? Did you or do you plan on replacing the cam bearings at all?
ericsanchez2005 1 year ago
@ericsanchez2005 Had 39000 miles when installed. As of now the car just reached 50k miles. Only problems that have come up are the typical piston slap noise at start-up but it goes away in less than a minute of heating up. Have not had any engine issues with the cam swap though and cam bearings were left alone.
Brutality110 1 year ago
@Brutality110 Dude... Are you tuned? I have 110,000 Miles on my Firehawk... What do you think bro..
To Cam... or not To Cam..
ericsanchez2005 1 year ago
@ericsanchez2005 Ya it was dyno tuned by precision motorsports. There are a lot of factors in deciding if you want to cam it or not. I suggest you check out ls1tech dot com and search on there for info they give good thorough advice.
Brutality110 1 year ago
@ericsanchez2005 with a cam like this.....sure.....but a big one like ms3/4 id rethink it.....motors like to grow old with there mod friends....hard to teach old dogs new tricks...but hey...you can always rebuild it forged
kief4diamonds 1 year ago
that exhaust is dancing. id stabilize it.
kief4diamonds 1 year ago
@kief4diamonds After I put the cam in the stock motormounts did not last much longer as well as the tranny mount. Replaced everything with prothane poly mounts and now its rock solid and puts the power down much better.
Brutality110 1 year ago