Iron 883 2

[horey100]

The tank lift is just a matter of a couple of flat metal brackets {made mine out of the reflector bracket around the number plate} drill some holes and get rid of all the plastic crap under the tank and then spend an hour tucking all the wires up under the tank channel, once you start its just a matter of following your nose.

[vpffp1234]

how do u do the tank lift?

[mercadeti]

the best music for the best bike!

[jman187187]

Sweet thanks.

[horey100]

The bars were a snap except for the left grip, I think they glue them on with Tarzan grip, but half an hour later and some swearing it was done

[jman187187]

Any troubles putting the bars on?

[horey100]

Yeah wire cutters and some eleco tape and hey presto, I lifted the tank for the look but it sure helped with the wires.

[jman187187]

Did u raise the tank to fit the wires?

[jman187187]

Yeah looks sweet. So pretty easy to do?

[horey100]

Only took about 2 hours to get rid of all the plastic and tape up all the wires,then tuck it all under the tank. and moving the coil and ignition another couple, but all in all I think it really changes the whole look.

[jman187187]

Nice!! was it hard to clean up the area above the motor?

[horey100]

the bars are just some flat drag bars dont know who makes em, the speedo is the original, in a bracket i made out of some thin steel bracing , but it does the job. And yeah the number plate is standard australian issue.

[77oldiais]

nice! what kinda bars? and speedo kit?

[carlsone25]

u ever figure out anything about the bars on this bike?

[jacropley4]

Cool rear fender license plate! Where did you get it??

[mistajace]

@jacropley4 i think youll find its an australian bike. they come stock like that.

[mistajace]

Respond to this video... what do the lowered shocks ride like are they 11'?

i wanted to get some but she rides fairly hard as it comes stock.