Drozd Blackbird full auto chip mod

[Taxarod]

Thats a huge solenoid..

[greenleafbrandi]

hmm i was under the impression that this weapon was fully automatic from the factory. i was aware it had a selector, but was always pretty sure that it was semi burst, auto....

[sithadmiral]

@greenleafbrandi the burst are full auto, at six shot burst each time you pull trigger it shoots six bbs, but you need the mod for full auto continuos fire, the gun will shoot as long as the trigger is pulled.

[sithadmiral]

If you haven't gone to bulk air or co2, I would recommend it cause you will go thru a lot of bbs at full auto.

[IBNZnate]

that's all you have to do is put that chip it.

what els would you recomend?

[thegodfather963]

does it really need this isnt it full auto with 600 rpm and 6 round burst on or am i wrong

[sithadmiral]

@thegodfather963 no 6 round burst is a 6 round burst.  At full auto there is no pause between bursts. At full auto you get 600 rpm 900 rpm and 1200 rpm.

[Adammartini]

so does this change the 6 burst to full auto so u still have semi, 3 burst then full auto? or does this change it to full auto always?

[sithadmiral]

@Adammartini yes you are correct, single shot 3 shot and full auto. 600 bb per minute 900 and 1200.

[Iamninjaronin]

woot radioshack

[ExoticSpotting]

That should keep those squirrles out of my bird feeder. :)

[MrGrimmv2]

Or you could be a squirrle baffle, but this is funner.

[xFalseTruthx]

Thank you for the demonstration!

What's the rate of fire changed to? The old one was set at 1200 rpm, but people have suggested a 900 setting.

Very nice work! Will be building one soon.

[elvensbane]

what does this do and why do people say they worry about the wear and tear?

[sithadmiral]

It allows you to shoot full automatic instead of 1,3,6 shot bursts. Using full auto may decrease life span on seals and other components.

[syganstar117]

theres a slight glitch whenever u 1st switch it on, the hammer will fire and hold until u press trigger a few times, it released. and i m having problems with it not firing at full power, inconsistent, did adjust the hammer but still not working . anyone know wat i didnt do ?

[sithadmiral]

I'll give you 5 mins back, there's not much to remove and replace new chip. It's difficult to film and solder at the same time. besides we're a small time production company.

[secularskunkfile]

awsome just bought the gun would like to get a longer barrel, where did u get that barrel at?

[Cosmosis]

Dang I GOTTA get me one of them chips soon!

[miketong2007]

good work Totalh.