Yusuf Begic's EVO 2 street car goes 200 mph @ Texas Mile

[thfelipeth]

very nice!! nice to see one in the states

[mawk27]

Very impressive. You definetly left 5-6mph on the table on that pass on the top end. Eitherway, you're in the club. Hope to join you in 12 days.

[sopirah]

i like this,can go 200mph zone, but still civilized

[AzumaRikimaru]

I too would like to know the gear ratios, also what tuning to the engine did you do

[FlyinEvo2]

@AzumaRikimaru

Sorry for the delayed reply, EVO 3 gearing and final drive, 25" tires, Arias 9.5 to 1 pistons, Crower rods, Kiggly valve springs, Kiggly HLA restrictor, MLS head gasket, FP 4r intake, FP 5r exhaust, FRH intake manifold w/Q45 tb, Autronic tuned by me, E85 fuel. Send me a message if interested in a tune. This set-up made 855 awhp at 40 psi with a very "soft" tune. Same long block for over 3 years at no less than 700 awhp.

[knobcheese69]

@FlyinEvo2 how hard does it rev out man? i saw a pegged tachometer there. i'm surprised your long block has taken 3 years of shit with high revs/boost/CR. derfinitely admiring.

[Lollidsm]

Nice run Yusuf. Congratulations. Are there more events planed for you?

[zortzy]

Nice run!

[groov33]

Nice work, just wondering if you have changed the gear ratios?

[FlyinEvo2]

@groov33 EVO 3 tranny and ratios with a 25" tire (225/50 R 16).

[groov33]

@FlyinEvo2 nice one, i didnt think the std ratios would get that high, ive done about 220-230 km/h in 5th in mine and it was revving at about 5000rpm ish

[OhThkU]

Nice work! How did you get an Evo 2 into the States?

[FlyinEvo2]

@OhThkU

A shop that built SCCA rally cars had an importers license and brought them in for race only use.

[OhThkU]

@FlyinEvo2 Right on, thanks for the reply. :) I wish I was in the position to get one right now.

Congrats on the MPH btw!

[tallguyfocus]

Maybe you should slap some aero on there and stay at WOT til the end next year! Still insane.

[FlyinEvo2]

I know Eric! WTF! lol. The car started moving around quite a bit. Without the luxury of big breaks and a chute I decided that would have to do.

[420evo420]

nice to see your car out there. where is douglass autoworks?? i remember seein this car at devo tuning

[FlyinEvo2]

There in Roselle, IL.

[AMSEric2]

What the hell did you let off for wuss?? :-D