drycell test 5

[kdkinen]

wow, thanks!!!!!

[kdkinen]

i think i heard someone say that 6" 21 plate is the best for 12 volts, but for 8" plates 24 volts.

although i realize by balancing the volts & amps, it's the same, but over 6" plates, the voltage gaps are too low between plates.

-- your vids are good

[partwerks]

What works best with the arrangement for holes where gas exits and water comes back into the cell?

[d3adp001]

need to be more specific, what do you mean by works best with the arrangement for holes? Are you refering to flow?

[kratomosphere]

what do you use as electrolyte? In my research caustics will do a number on neoprene. I have been working with EPDM and has great resistant qualities to heat and chemicals, But i dont know how it would work as spacers in a dry cell. May be slightly conductive.

[vshart]

this resolt of descoloration is acure after how much working time?

[d3adp001]

starts after a dozen or so hours, but it really is dependent on voltage. I overdrove these a little bit to find the bell curve in eff. The discoloration doesn't seem to affect performance.

[johnmcphail1999]

What kind of gasket? and how thick are gaskets? Im currently testing a 8x8" dry cell with 1/16" gasket, also made 1/8th gaskets to try but have not tried yet, Thanks

[d3adp001]

gasket material is neoprene, 60a hardness, and they are 1/16th thick.

Good luck, and if you can post some videos of the cell.

[d3adp001]

well apparently the resoloution is on youtubes end.