i'm using it with hexane i noticed that it finishes in less than 15 minutes. i put the bath temperature at 85 because in the manual it says 20 degrees above the solvent boiling temperature. is that right?
why would you set the bath temperature that high? The whole point of a rotary evaporator is to remove some solvent at low pressure and low temperature.
Amazing !!! your voice is SEXY !!!
1stPal 8 months ago
Go and visit Buchi website and look for the solvent list.
For hexane, applying a vacuum of 335mbar, you just have to heat up to 60°C !
fafaplouf 10 months ago
This has been flagged as spam show
" in the manual it says 20 degrees above the solvent boiling temperature" ...depending of the presssure value you are thanks to the pump !!!!
fafaplouf 10 months ago
how do you get your product out of the flask?
bmays002 1 year ago 3
good video
thank you very much for uploading it
i'm using it with hexane i noticed that it finishes in less than 15 minutes. i put the bath temperature at 85 because in the manual it says 20 degrees above the solvent boiling temperature. is that right?
rynhj 1 year ago
@rynhj
why would you set the bath temperature that high? The whole point of a rotary evaporator is to remove some solvent at low pressure and low temperature.
analychemist 1 year ago
okeee
murni267 2 years ago