Bedini pulse Motor from a car alternator

[333kgb]

The potentiometer is connected to a 24 gauge outside coil wire. My 1N4007 diode is connected to the positive on the secondary battery. Then the outside 20 gauge wire runs to negative on the secondary battery and on the positive on the primary battery

[MrJetjoe]

1 law of free engery: run timemust be > charge time!!!!!!!!!!!!!!(>=greater than)

[toranarod]

@MrJetjoe

hi thanks for the help

you are totally right this vid is two years old I have come along way since then

cheers Rod

[MrJetjoe]

its the scale of the experment thats wrong. and not using the moter ratings right.and the amp hr rating of the batterys.

[tjamassey]

I strongly suspect that the reason people claim they get over unity here is that they are measuring input power wrong - since it is pulse driven. You cannot use ordinary meters.

[sypha0x]

Not really, I have seen direct tests being conducted on the Capacitor itself instead of the battery...batteries tend to lie but capacitors are straight forward with your measurements

[sorova]

The back-emf that a motor induces is well accounted for in the basic equation for a dc motor. There is nothing new and the efficiency is never over unity.

[sypha0x]

well not exactly over unity but what I can say is that the John C. Bedini patented circuit sure does show an increase in Voltage/Amperage.... that is, the flux fields created by the coils is collapsed because of a reversal of the magnetic field in the magnetized pole pieces thus allowing the capture of available back EMP energy. Additional available energy may be captured and used to re-energize the battery, and/or sent in another direction to be used as work.

[sypha0x]

So your definitely not getting more than you put in but you do harness the extra work that is being wasted

[sypha0x]

For a capacitor of value C farads the energy E stored in it as a function of its voltage V is E = 1/2xCxV^2. For instance, a capacitor of 1000 Microfarads with a voltage of 100 volts contains 5 joules of energy. The voltage across a capacitor then gives an unambiguous measure of its energy.

[sypha0x]

A Bedini motor when tuned turns at a constant rpm. This means that the pulses generated will be uniformly spaced in time. An oscilloscope can be used to monitor the voltage across the output capacitor. The drop in voltage when the capacitor is discharged then gives energy outputted: E = 1/2xCx(Vmax^2-Vmin^2). Multiplying this by the number of pulses per second (determined from the oscilloscope sweep) gives the total output in joules/second (watts).

[sypha0x]

This method can be used for any capacitor pulse charging system.

Input power can be measured by putting a small resistor in series with the battery and measuring its waveform using the oscilloscope.

[sypha0x]

In other words you can see the capacitor charging and discharging the extra load from the back EMF

[harryfodder]

how are people charging their batteries with the bedini circuit? isn't that over unity?

[weeeendog]

what the hell are you doing . . . molesting that alternator . . . fondling its wires?

[lvildos]

mission not accomplished if the purpose of this video was to aid replication. My suggestion is you need to first explain why/how the alternator modification(s) may/can accomplish the Bedini effect

[stovebuilder]

I was wondering if you would allow me and my son to buy from you all the nessary parts and drawing as of what you have put together here. It is very interesting and we where looking for a project like this we could build together but I dont know all the symbuls for all the parts nor exactly how they would be connected. So would you mind selling us all the pieces we would need to see this work ourselves. thanks

[plopzzzzzz]

Hello,how can i change an alternator into a 12volt dc motor?Thanks Peter

[2giveup]

well its magnets and copper use a different type of voltage regulator? i spin magnets using magnets. no copper this turns a dc generator with power invertors to not strain the gen... next step will be to add copper and the proper regulators to store power for later use .well at least im not an electrician. which makes things easier.

[RockManAU]

PS I rated your vid as Awesome but...

[RockManAU]

good, more plz

[xsyar]

depending on impedance in the coil, there is a good thing to pwm the pulses to avoid dc current heat up the coil. thats how they do all switched powersupplies today and motor controllers

[toranarod]

Looks like my video editing is having a sound sink problem.Sorry.

[TeslaBlue]

@toranarod All MAGNETS are OVERUNITY devices! It's not science-fiction. It just proves all college physics WRONG.