You mention having issues with circles - It almost looks like your X-belt is just a hair too loose. Perhaps tensioning that a bit more will improve your circles?
@Upuauta the cooling of the pla it to help prevent any warping. if the part gets thick then it holds some heat and can cool off unevenly. layers going onto warm pla will shift when a new layer is added on top since it hasnt cooled off enough to support a new layer.
your whistle should sound like this if you do it right
watch?v=5-CxCUZsDHc
dzuari 2 months ago in playlist Uploaded videos
Comment removed
EtherDais 10 months ago
You mention having issues with circles - It almost looks like your X-belt is just a hair too loose. Perhaps tensioning that a bit more will improve your circles?
EtherDais 10 months ago
@EtherDais It takes the right touch and a lot of practice to get right.
GeoDroidJohn 4 months ago
To cool the PLA so the next layer has a good base. This fan is also cooling my electronics and a couple motors.
GeoDroidJohn 10 months ago
Can you describe a newb like me what the fan is for, please? Ok, for cooling but why? Thanks in advance.
Upuauta 10 months ago
@Upuauta the cooling of the pla it to help prevent any warping. if the part gets thick then it holds some heat and can cool off unevenly. layers going onto warm pla will shift when a new layer is added on top since it hasnt cooled off enough to support a new layer.
badkangaro0 8 months ago
@badkangaro0 Thx, for the clarification.
Upuauta 8 months ago