No, the input shaft seal on the tranny leaked fluid onto the clutch, and it would gum up and get stuck. Someone had drilled and tapped a little hole in the bell housing to allow brake cleaner to be sprayed on the clutch plate to free it up, but it wasn't helping anymore.
Two thoughts. First, Most people remove the drag links from the steering arms and leave the box on the trans case. Second,.That's the dirtiest MS carb in history.
One week since the video of the take apart. I still have not written the strategic plans or flow charts to get the thing back together again because of an emergency: I am working on the Bush-Cheny war plans. lol:)
i put a 87 bronco in my 8n its a beast but it needs a starter or a relay i cant tell i think its the relay.
TheGuywithecamera 5 months ago
did your throw out bearings rust to the clutch and stick, that happend to ours
rangerkid777 2 years ago
No, the input shaft seal on the tranny leaked fluid onto the clutch, and it would gum up and get stuck. Someone had drilled and tapped a little hole in the bell housing to allow brake cleaner to be sprayed on the clutch plate to free it up, but it wasn't helping anymore.
14erjohn 2 years ago
Two thoughts. First, Most people remove the drag links from the steering arms and leave the box on the trans case. Second,.That's the dirtiest MS carb in history.
pumkinvine 3 years ago
this vid helped me out a lot because i am restoring a 1948 8n.
badasswhiteboy93 3 years ago
music was fitting but the content and the photos are great. play the video backwards and you'll be plowing in no time!
stoporyouwillgoblind 3 years ago
One week since the video of the take apart. I still have not written the strategic plans or flow charts to get the thing back together again because of an emergency: I am working on the Bush-Cheny war plans. lol:)
granskare 4 years ago
hey! much better than the first vid and the music is better. I think it's the boys of AhSeeEfAhr group :)
I will post this to friends.
granskare 4 years ago