Honda CB 500 carb sync

[shydragon1978]

ok i bought a carb synchronizer and i cant figure out where to hook it up at someone pls help me i have a 99 suzuki gs 500 e

[thrombox]

What size diameter of tubes did you use and how did you fit them on the inlets?

Did you just pull the see through tube over the inlet?

[amagakeresztje]

@thrombox,

The inner diamater is somthing 4mm as far as I remember.

You have to purchase an OEM Honda "threaded sleeve" what you can drive into the carb's vacuum hole.

Or (as I did) you manufacture this by a local turner.

Here is a how-to about this method, hope this helps! ;)

Cheers

[thrombox]

@amagakeresztje Thanks very helpful.

Instead of a threaded sleeve can I not just put the tube over the inlet?

...and how about using 4-stroke oil instead of water or 2 stroke oil in the manometer? Probably not a good idea?

This is to stop the vibration you see, get more of an accurate set.

[thrombox]

@amagakeresztje Thanks very helpful.

Instead of a threaded sleeve can I not just put the tube over the inlet, if I bought lets say a 3mm ID tube?

...and how about using 4-stroke oil instead of water or 2 stroke oil in the manometer? Probably not a good idea?

This is to stop the vibration you see, get more of an accurate set.

[amagakeresztje]

@thrombox,

The inner diamater is somthing 4mm as far as I remember.

You have to purchase an OEM Honda "threaded sleeve" what you can drive into the carb's vacuum hole.

Or (as I did) you manufacture this by a local turner.

Here is a how-to about this method, hope this helps! ;)

bit ly/aj4ZRe

Cheers

[gregger454]

I suggest using 2-Stroke oil....if you suck it into the engine it will just smoke! Plus it's more viscous and gives a better reading!!!

Cause ya can't compress water!

[fuxgo]

köszi!

[fuxgo]

szupper tudomámy,én is próbáltam az én Honda CB-1 en,de állandoan berántja a vizet!:( meglehet tól elvanak álitva a karburátotjaim?v.inkáb vegyek CarbTune gépet és azzal a higanyal könyebb lehet?

[amagakeresztje]

Hali!

valószínűleg az a helyzet, amit írtál! Ebben az esetben már csak a higanyossal tudod beállítani. Más lenne a helyzet ha előtte ötször csináltad volna a szinkronizálást, akkor azért tud gyorsan cselekedni az ember :) Gyere fel a sportmotorra, cb500 topic. Ott CBLaci barátunk minden titkot megoszt velet CB-1 ügyben! ;)

Széles utat!

[papakeetee]

did you know this can be done with vacuum gauges and and multi gang valve from a fish tank,you know the valves that give air to the fish,use this to throttle the vacuum daown to give you a smooth needle works great!!

[amagakeresztje]

okay, maybe safest solution like using water! :) But no problem this water manometer at all... Thx!

[amagakeresztje]

Köszi! :P

[funkykutya]

Nagggggyon tudományos :)) Fasza lett a tool!