ok thats good to know. do you think you could provide an rpm table or know where i could source one from?? because im running a 500mm blade with 3.5 thickness for almost all work but larger slabs. but do not know what rpm to set the saw at for different blades as the manual does not have one in it. any help would be great!!
The video shows the litox performing diverse operations (sculpting and countertop sawing) with the same blade. The optimum blade for sawing including miters is 18 inch x 3mm thick running at approximately 1,200 rpm (speed for granite). Sculpting requires a thicker blade (7mm) and a different set of parameters. Please feel free to contact SALEM for further discussion 800-234-1982 (336-766-1104).
Step cutting increments vary depending upon material being cut and the blade quality average approximately 3-5mm. Please feel free to contact SALEM for further discussion 800-234-1982 (336-766-1104).
ok thats good to know. do you think you could provide an rpm table or know where i could source one from?? because im running a 500mm blade with 3.5 thickness for almost all work but larger slabs. but do not know what rpm to set the saw at for different blades as the manual does not have one in it. any help would be great!!
EratiCManiaC 2 years ago
You can access our Blade Data Sheet (down load pdf) in the Resources Section Of the SALEM Stone website.
Sorry, YouTube restricts posting URL in comments. Go to SALEM Stone web site, Resources, Information Sheets, Blade Data.
salemowner 2 years ago
oh and what blade thickness for it too? just want to be able to run more efficently if you can help
EratiCManiaC 2 years ago
The video shows the litox performing diverse operations (sculpting and countertop sawing) with the same blade. The optimum blade for sawing including miters is 18 inch x 3mm thick running at approximately 1,200 rpm (speed for granite). Sculpting requires a thicker blade (7mm) and a different set of parameters. Please feel free to contact SALEM for further discussion 800-234-1982 (336-766-1104).
salemowner 2 years ago
do you know what MpM and increment setting the saw was set at for those miter cuts??
EratiCManiaC 2 years ago
Step cutting increments vary depending upon material being cut and the blade quality average approximately 3-5mm. Please feel free to contact SALEM for further discussion 800-234-1982 (336-766-1104).
salemowner 2 years ago