Pulling Bedsides With Metul Munky & Dr. Jones

[rnbaer]

I dont know if thos is a stupid question lol but could i do this same proceedure on my 2000 s10??

[streetphase]

will this work on 2nd gen blazer?

[socalfirekid]

MAKE MORE VIDEOS. i want to see the dimes in anction.

[dirtlife2001]

seriously NOT the cleanest way to be done. instead of cutting it along that bed seam, leave at least 1-2 inches of material and use 8-10" wide of thin sheet metal, tech screw it in place once u get the fender pulled out to desired width using a bottle jack or strap to something solidthat wont move. that waythe damn wheel well is covered up and it looks clean and notall booger welds or the thin ass metal wont have burnt through...asfor the bedside supports....use a whole piece of that stock

[KohlfromSD]

@dirtlife2001 amen brother

[Mr144rider]

i did this with my truck pulled it out about 3 inches had no crease in it at all and looks sick and saves u money by not buying fiberglass fenders.

[speedymcfastpants]

i would so trade my runner for a lil offroad jimmy

[theboywhohadnos]

would this work on a two door jimmy???

[HAMMERxHCA]

nice video. good shit man!

[MrAndrade91]

ha have fun cut your truck up...

told my dad i was gonna cut my truck up and hes said "boy if you cut that damn truck up...imma cut you up"

[DownHillKingsDHK]

very nice idea, instead of welding "tickets" could you just bend a piece of flat sock and weld it all the way around? cause i live in wisconsin and the salt in the winter would do wonders in the new openeings in the fender

[willystylee]

i pulled mine about 4-1/4" without crease. dont go any further tho

[idiot12494]

can you pull them like 4 inches, or would that cause creasing?

[4xdanx4]

does this work the same on a 1st gen s-10?

[WILLDAMIEN]

Nice vid guys...u guys made it look easy and simple!!