problem in mini RC Helicopter

[adilrazzaq1]

Mine does the same

[maseizdabeast]

ok to allll of you guys you need to control the trim the trim is the tiny blade in the back of the helicopter that spins...there is usually a tiny knob that you twist opposite the helicopter spinning way... or sometimes buttons...

[Zemo999]

Yeah usually a gear problem OR the screws holding the blades on the shaft.

Turn the upper blades, see if a gear turns down in the heli body.

Then turn the lower blades, make sure a gear turns in the lower heli body.

Then just check to see if it's not turning the gears because the gear is not lined up, or if the screws holding the blade holder aren't broke off in the shaft.

Hope this helps...

[trevan2011]

thats what mines does

[fernanumero3]

help my helicopter does not spin the wings plz help me it does not fly or spin

[robertlam18]

just need to trim the rotar using the switch on the romote control

[iliveonjupiter]

What I do is I just turn the opposite way

[MARIO82825]

you mait have a unbalanst blaid or the blade is twisted you need to hold in dawen or sumthing and slowey pawer up and woth the blades from the side so you can see them flex up if one flexes up more than tha other one you have to cerfuly twist it to get them to trach together and you do that in pers the top per then the botom per i hope this helps .

[chandlerandkrishna]

mines does the same! Mines wont go up! even if i trim it the same thing happens ! all it does is it rotates really fast. did tariq4you finally get it to fix cuz this vid is from 2009!

[SuperTunics]

how do you fix the trim?

[mediaman1994]

fix the trim



[richardofyorke4]

nearly 100 percent sure a problem in the gears..... check it

an heli spinning like this is mainly caused by a damaged rotor blade gear,

or the secoondary balde gear... hope i ve solved problem .. :)

[jkl3369]

u got this at hobby trend in nz didnt u well that guy at the shop fixed it

[CuteKiller81]

there is prob in tail fan... cahnge it or make that it's working fine........

it is only salution of it.

[GGames2009]

It does that to me while it is on the ground but when I edit the trim it stops, but then it spins like crazy in the air :S!

[aghahamidgol]

I had the same problem and i tight the screw. Now its fine and fly :D

[Etrain94]

if you've cleaned the hair out of the tail blade (removed it) and still get the spinning problem take the tail blade off and run the tail motor in alcohol 70-90% for 20 seconds or so. a shot glass is a good size container to use. now i do it once a month just to keep the motor clean.

[pereragerard]

check you'r top roter blades are loos.And tight the screw.

[carlaodraincem]

mine did like that but it can fly, please help me.....just bought it tish morning

[snare76]

My helicopters main sharft bent the day i got it -.- i hope to get a new one soon

[ParaglidingManiac]

It's the thing that you didn't trim it, or that you have bended the mains haft. So It doesn't have enough power to lift off because of the vibration.

[southpark5005]

open your helicopter and see if a wire is lose because that's what happened to me when i crash it all kinds of times

[Obibelona]

it just need some trimming. i have one of those and it works very nice.

[gtokarsk]

Trimming? Or adjustement of the proportional i=on the receiver under the canopy? Could be either I'd quess?

[monkeynuts1972]

just needs triming up mate so dont give up yet:-)