And first of all... to recharge ur heli u need connect it to controler and heli need to be turned OFF, but i see problem in that, to when u turn ON ur RC the lights not flashing so this is kinda bigger problem
you charge the helicopter with the panel bit which you can remove it is at the bottom of the controller make sure that it is charging for at least 15-20 minutes if the controller is on light button is flashing it means that it is not at full battery READ THE FUCKING MANUAL
No led light in copter is almost certainly bad or dead heli battery - try recharging with usb cable if you have one (lots of indoor helis come with one) or send it back.
I bought a 9808 and RC was dead, I fixed it by resoldering a few dry joints inside.
You have to give it full throttle for the controller to recognize the heli. Then back off. Try this a few times to make sure that's not the issue. The heli has an inner red lights that blinks quickly once it's recognized. The only change of bandwidths can be only done on the controller. The heli is a fixed bandwidth. The bandwidth letter is located on the heli where you plug it in. Good luck.
The problem on mine is different. I received the same one today, from focalprice. I turn on the helicopter, the lights goes on, the I turn on the controller and... The heli doesn't move! I tried turning on the controller before the heli, I tried to change the channel in the controller... but nothing happens, the helicopter does not move.
In the instructions says "set the band on transmitter same to the helicopter", but i can not see any switch to change band in the heli..... :(
Ok best bet one of the battery wires is broken. I have had this problem before too.
Take the body off & check to see if the red or black wire from the battery is broke.
The battery wires are usually soldered into the joints that are the FARTHEST apart on the circuit board...(one on each side).
Zemo999 4 months ago
charge that thing first :))
scorpionreptyle 8 months ago
mayebe the lights are the problem try flying it its what happened to my 9808 i changed its lights!
superkito111 9 months ago
And first of all... to recharge ur heli u need connect it to controler and heli need to be turned OFF, but i see problem in that, to when u turn ON ur RC the lights not flashing so this is kinda bigger problem
Pietrovek84 1 year ago
Srry but did u record it with banana?? i dont see did u was properly turn it ON ;)
Pietrovek84 1 year ago
you charge the helicopter with the panel bit which you can remove it is at the bottom of the controller make sure that it is charging for at least 15-20 minutes if the controller is on light button is flashing it means that it is not at full battery READ THE FUCKING MANUAL
MrApache101 1 year ago
No led light in copter is almost certainly bad or dead heli battery - try recharging with usb cable if you have one (lots of indoor helis come with one) or send it back.
I bought a 9808 and RC was dead, I fixed it by resoldering a few dry joints inside.
QC on these 9808's out of China is not so good.
cyanideisabitterpill 1 year ago
Buy better batterys!
g8enh 1 year ago
Charge it u numpty, i have 1 to that 1 actually, just charge it.!
PYKxGAMING 1 year ago
You have to give it full throttle for the controller to recognize the heli. Then back off. Try this a few times to make sure that's not the issue. The heli has an inner red lights that blinks quickly once it's recognized. The only change of bandwidths can be only done on the controller. The heli is a fixed bandwidth. The bandwidth letter is located on the heli where you plug it in. Good luck.
ChrisHansen1114 1 year ago
were did you buy it i cant find were to get one lol
hod05 1 year ago
The problem on mine is different. I received the same one today, from focalprice. I turn on the helicopter, the lights goes on, the I turn on the controller and... The heli doesn't move! I tried turning on the controller before the heli, I tried to change the channel in the controller... but nothing happens, the helicopter does not move.
In the instructions says "set the band on transmitter same to the helicopter", but i can not see any switch to change band in the heli..... :(
legumbro 1 year ago