The time has come for Free energy to be revealed ,But some very powerfull ppl don't want you and me to be free from energy costs,Get the blueprints for a real Magnet motor free enegy machine at LT-MAGNET-MOTORdotCOM ,Be part of the revolution!
@lykenth08 The rotor is made out of a platter from a hard drive, with 4 magnets (N, E, S, W directions) with North facing outward. I hot glued them on the platter and then taped them together to prevent them from shooting off.
I also have it sitting and hot glued onto a ovc connector.
My main issue is with my coil. Can;t seem to find enough wire to make a 900 turn coil. I have around 300+ on this thing and it is a little small compared to others.
How about useing other wires? iv gone up to 18guage and found there is more torqe. and from what i have learned over the years - have the inner hole of the coild the same size as the magnets - use al the surfice area of the magnet, hey try a north south configuragtion - works for me! same as hollow core - but a bit harder to start.
This has been flagged as spam show
The time has come for Free energy to be revealed ,But some very powerfull ppl don't want you and me to be free from energy costs,Get the blueprints for a real Magnet motor free enegy machine at LT-MAGNET-MOTORdotCOM ,Be part of the revolution!
urgencyharviefcem 1 year ago
This has been flagged as spam show
Free Energy is real but the coverup is strong, if you are interested in a REAL free energy machine then
just search for the LT MAGNET MOTOR in the youtube video search , it is probably the ONLY working magnet
motor out there. Join the free energy revolution!!
porscheghcje 1 year ago
does it have to be a 12V battery?
Ratchet0053 1 year ago
@Ratchet0053 the electronics are rated for 12 v, but I guess you could modify it to run on less voltage or more
pkrska 1 year ago
hahah and star gate on in the back ground!
Hi, Sweet set up, from what i could not hear yours has verry tiny to No vibration? excellent calibrations. Best of luck to future builds
lykenth08 2 years ago
@lykenth08 The rotor is made out of a platter from a hard drive, with 4 magnets (N, E, S, W directions) with North facing outward. I hot glued them on the platter and then taped them together to prevent them from shooting off.
I also have it sitting and hot glued onto a ovc connector.
My main issue is with my coil. Can;t seem to find enough wire to make a 900 turn coil. I have around 300+ on this thing and it is a little small compared to others.
pkrska 2 years ago
How about useing other wires? iv gone up to 18guage and found there is more torqe. and from what i have learned over the years - have the inner hole of the coild the same size as the magnets - use al the surfice area of the magnet, hey try a north south configuragtion - works for me! same as hollow core - but a bit harder to start.
lykenth08 2 years ago