screet123 can you share with me your experiences (specifically on potentially weak landing gear) and your radio settings for flap+elev, and at approximately which throttle setting does this plane come in gently?
@pimvanpelt , At first i replaced elevator servo whit same type mg-servo because it was "luckily" broken right out of box. Landing gear structure feels strong and i think that's not going to be the problem, however the mechanism it self may not work properly as i found out. I replaced other faulty landing gear with HK "Digital Servoless Retractable system " that fits in whit just small modifications.
@pimvanpelt , Make sure you test your landing gear every time before taking off. For the flaps i didn't use any elevo mixing. I 3-point switch for the flaps (up, middle and down) but i have only used the middle position for landing. As i come to final approach whit flaps the plane almost glides it self so just gentle throttle and it lands smoothly. I also use d/r for all control surfaces except for the rudder.
screet123 can you share with me your experiences (specifically on potentially weak landing gear) and your radio settings for flap+elev, and at approximately which throttle setting does this plane come in gently?
pimvanpelt 5 months ago
@pimvanpelt , At first i replaced elevator servo whit same type mg-servo because it was "luckily" broken right out of box. Landing gear structure feels strong and i think that's not going to be the problem, however the mechanism it self may not work properly as i found out. I replaced other faulty landing gear with HK "Digital Servoless Retractable system " that fits in whit just small modifications.
screet123 5 months ago
@pimvanpelt , Make sure you test your landing gear every time before taking off. For the flaps i didn't use any elevo mixing. I 3-point switch for the flaps (up, middle and down) but i have only used the middle position for landing. As i come to final approach whit flaps the plane almost glides it self so just gentle throttle and it lands smoothly. I also use d/r for all control surfaces except for the rudder.
screet123 5 months ago