How to make coils for a Bedini motor

[Buyerisland]

QUESTION.... When making BiFiler coils for the Bedini, is there a proper direction or way to wrap the coil so it will be a "North" coil ? I read on some forums that the person said "We wound the coil wrong and it was a South Coil so we had to reverse the wires on the SSG circuit to make it a North coil"... Not sure if I understand that... Thanks

[ROBINCRIDLEBAUGH95]

hi i want to make one for the core can i use cote hager insed

sorry for the spelling am not good at it but yeah can i use steel cote hangers

[usedbandage9]

I have a few questions, hopefully someone can answer them:

Does putting epoxy on the side that points at the wheel cause any problems? So should i only epoxy the back, or both sides?

For the core of my coil, im using tie wire (for rebar). I straightened it out and cut it the right lengths...should it work?

Also, if making a bedini with 3 coils, does it require trifiar wrapping, or can you use bifilar on the 3 coils?

[meganexor010]

hi, friend.

I want know name of the bar steel ( I think is steel ), you utilize for make core, please

Sorry my english is bad.

[powermaks]

scrap the drill and make it plug in to the wall and where the swich is replace it with a pot. and kill button

[kdkinen]

oh hey, i read that the coils being too tall can be a detriment, its determined by the magnet: you take a paperclip & find the point where it barely starts to lift it & that is your correct coil height.

also, you make them 1.5 times wider than the height

[oioioi3000]

Is 33SWG OK for the Trigger Wire?

[oioioi3000]

Standard Wire Gauge(SWG) Just To make things clear