@treepog just a 1/8 rougher type bit. it's not an "endmill" type, but just a filing texture. I just looked on Dremel.com and found the "562 Tile Cutting Bit" which is pretty close to what I used. i don't care for the fluted cutters when hand-holding the tool because they are very hard to control.
Thank you for the reply. I am getting ready to install a couple of these and this will help me. Thanks again!
treepog 1 year ago
Nice vid. What tip are you using on the dremel?
treepog 1 year ago
@treepog just a 1/8 rougher type bit. it's not an "endmill" type, but just a filing texture. I just looked on Dremel.com and found the "562 Tile Cutting Bit" which is pretty close to what I used. i don't care for the fluted cutters when hand-holding the tool because they are very hard to control.
helichair 1 year ago
This has been flagged as spam show
Reminds me of the dentist 2:28!
tetedepoulet 2 years ago
Comment removed
tetedepoulet 2 years ago
Great video! Accon should pay you for doing this.
russiahowto 2 years ago
Guys its very important to use a vacume cleaner just like the person on the vid is doing because its very dangerous if you inhale fibreglass dust.
kurtfalcon 3 years ago
chamillion paint ?
sharpstown08 3 years ago
nice! what type of dremel do you use? can you give me a link?
magnusdahlnorway 4 years ago
nice job man... looking at doing some boat work myself this weekend. Glad to see I can use my dremel :)
jiminoc 4 years ago
waht vaccum do u use
holman26 4 years ago
craftsman 4gal wet/dry shopvac
helichair 4 years ago