Hi,
The best thing to do is: to get 5V or 6V LED-s and to use Futaba connector to connect in to your receiver.LED-s are polarity sensitive!
Just go for some forums to get the right answer about the remote switching mode!
All the best!
Regards;
Richard.
richardbenko1 4 months ago
@richardbenko1 Thanks for the info here my friend. I will look at some forums about the switching modes. Thanks again.
DJPaulgee1 4 months ago
I've just built my own set of nav lights, but i can't work out how to connect them to a receiver? They work fine by connecting a 6 or 9 volt battery, but how do i get them to work remotely from my transmitter and receiver?
Hi,
The best thing to do is: to get 5V or 6V LED-s and to use Futaba connector to connect in to your receiver.LED-s are polarity sensitive!
Just go for some forums to get the right answer about the remote switching mode!
All the best!
Regards;
Richard.
richardbenko1 4 months ago
@richardbenko1 Thanks for the info here my friend. I will look at some forums about the switching modes. Thanks again.
DJPaulgee1 4 months ago
I've just built my own set of nav lights, but i can't work out how to connect them to a receiver? They work fine by connecting a 6 or 9 volt battery, but how do i get them to work remotely from my transmitter and receiver?
DJPaulgee1 4 months ago