so you completely control the power to rear end just by pressing down on your clutch when ya dont wana move? that works that well without burning up belts?
@CAMOTRUCKN I use to run two "A" belts side by side but then I went to a single "B" belt and it seems to work good. You just need to make sure that the idler pulley has lots of room to move up into the belt without the belt touching itself on the inside. I've got a couple years of use out of one belt.
@ils360 It's the 13 hp Honda that I had on my kart. It's got an 11 hp head ported and planed .040", AGK .350" lift cam, ARC billet flywheel and connecting rod, chromoly pushrods and stainless valves, double valve springs, Raceseng billet aluminum roller rockers, Mikuni BSR36 carb from a DRZ400.
@ils360 It wasn't bad. I never had it stock on this tractor. The first one in my lawn tractor evolution video, the red rear engine one had a stock 11 hp and you could get it to wheelie pretty easy.
so you completely control the power to rear end just by pressing down on your clutch when ya dont wana move? that works that well without burning up belts?
CAMOTRUCKN 1 week ago
@CAMOTRUCKN I use to run two "A" belts side by side but then I went to a single "B" belt and it seems to work good. You just need to make sure that the idler pulley has lots of room to move up into the belt without the belt touching itself on the inside. I've got a couple years of use out of one belt.
wertheroriginal 1 week ago
did that thing do a wheelie, that is awesome
joshuanewtonracing 2 weeks ago
@joshuanewtonracing Thanks.
wertheroriginal 2 weeks ago
does it make any difference if you removed the counter balance shaft
TheTRYALL 2 weeks ago
@TheTRYALL It has a little more vibration at idle but it smoothes out at mid to upper rpm and I think it helps it rev a little faster.
wertheroriginal 2 weeks ago
so you race and modify lawn mowers too AWESOME brother
V8Mike93 6 months ago
that thing rips for a 13hp engine
atractorkid7 7 months ago
@atractorkid7 Yeah it's pretty good, thanks.
wertheroriginal 7 months ago
what engine are you using and what has been done to it??
ils360 7 months ago
@ils360 It's the 13 hp Honda that I had on my kart. It's got an 11 hp head ported and planed .040", AGK .350" lift cam, ARC billet flywheel and connecting rod, chromoly pushrods and stainless valves, double valve springs, Raceseng billet aluminum roller rockers, Mikuni BSR36 carb from a DRZ400.
wertheroriginal 7 months ago
@wertheroriginal so that is why it is so fast.... what was it like stock??
ils360 7 months ago
@ils360 It wasn't bad. I never had it stock on this tractor. The first one in my lawn tractor evolution video, the red rear engine one had a stock 11 hp and you could get it to wheelie pretty easy.
wertheroriginal 7 months ago
@wertheroriginal cool i looking to build a racing mower my self
ils360 7 months ago
wow
memcu30 7 months ago