Good video Eddie. One thing that I have been told is to run a piece of wire in the motor block and manifold holes to make sure they are clear because sometimes rust will block the holes.
Thanks for this great video. 2 Questions: "water heater"? Not on every boat right? So a 20foot bow rider I can skip that part? Second question: I've always ran antifreeze via a gravity system through the outdrive... pouring antifreeze in the hoses at the thermostat (looks a lot easier) will it put antifreeze in the OUT drive also? And do I disconnect AND fill ALL 4 hoses? Thanks again!!
nice thx
vickie1648 4 months ago
Can u please tell me whats best if leaving the antifreez inside the block, or draine it? Im at chicago so its real cold up here. Thanks
MrMarine23 5 months ago
I have a video for that exact thing here: youtube.com/watch?v=CPIYwM7G-Wc
TheLessco 3 months ago
nice if you can make video for winterizing a closed cooling system ie a mag 496
larryd1773 6 months ago
good winterize but what if they have a small leak in the exhaust or engine. Over the winter that could be a problem.
al8675 1 year ago
what what dont even know how to buy a nutdriver
rbroberts226 1 year ago
what about the outdrive anything
izwild 1 year ago
@izwild if anything take it off to check for water. change gearoil and grease fittings
al8675 1 year ago
Good video Eddie. One thing that I have been told is to run a piece of wire in the motor block and manifold holes to make sure they are clear because sometimes rust will block the holes.
showntell49 1 year ago
Thanks for this great video. 2 Questions: "water heater"? Not on every boat right? So a 20foot bow rider I can skip that part? Second question: I've always ran antifreeze via a gravity system through the outdrive... pouring antifreeze in the hoses at the thermostat (looks a lot easier) will it put antifreeze in the OUT drive also? And do I disconnect AND fill ALL 4 hoses? Thanks again!!
solestine 1 year ago
Thanks Eddie.
gfsugar2plus 1 year ago