Thanks for you precious input (lol) as the one holding the standard. Yes I know about the secondary spark gap and will be adding it in steps as each step I want to understand fully to then see any overall changes. I put a nice coil under my first spark gap and now can see it on the scope. I already have the ferrite rods in the video but did not pull them out to show them - sorry about that. Thanks again and keep well.
@T1000LTU
Thanks for you precious input (lol) as the one holding the standard. Yes I know about the secondary spark gap and will be adding it in steps as each step I want to understand fully to then see any overall changes. I put a nice coil under my first spark gap and now can see it on the scope. I already have the ferrite rods in the video but did not pull them out to show them - sorry about that. Thanks again and keep well.
wattsup1004 1 month ago
Hi,
When your PSU gets blinking display instead of numbers, you are on right path.
Try to put ferrite rod from old radio (probably NH2000 type i believe) inside of caduceus coil. This should help with induction you need.
See if it heats on some point. If it does, you need insulaton there.
Also you need secondary spark gap to bulb and charge capacitor from Tesla secondary over diode before spark gap.
Good luck!
T1000LTU 1 month ago