One magnet no bearing Bedini motor 1.5 volt watch battery test vid 6

[imtotob]

Thanks Jonny for the info it will help a lot in my hho experiment (which circuit can you recommend)

plus slayer for lighting inside hho and maybe excte the hho plus ring magnets 

have fun enjoy

[imtotob]

Hi Jonny

Have you test ed your egg magnet in a glass jar with water if it will stir up the water

I ask this because im doing some hho experiments and

 want to speed up the hho separation from the plates

thanks

[jonnydavro]

Hi imtotob .I have a vid of two small sphere magnets spinning in a testube of water.They spin that fast that they create a vortex and spin in an air bubble under water as well as levitating up the tube.Have a look at my channal and you will find it.If you want to spin a larger magnet, a neo sphere would be the best candidate as the snake egg is not a very strong type of magnet so may struggle.Jonny

[transfusablepng]

Free Energy is real and its here! The Oil companies are doing everything in their power to stop these information. If you want a Free energy machine do a search in youtube for the LT MAGNET MOTOR , Join the revolution!

[jeannacav]

Very nice, johnnydavro,

smoooth.

jeanna

(I am just catching up.)

[jonnydavro]

Thanks jeanna.I tried this again the other day with my cylinder magnet rotor and it was running nice and smooth on 2.2mA.Regards jonny

[pyrodin123321]

Wow good work!!

[jonnydavro]

Thankyou.Regards jonny

[zebok13]

A pencil stub through a tube magnet with a sharpened point should rotate like the serpent egg. Either magnatized axially or diametrically, which way is best I don't know. Output is proportional to magnet strength, input and magnet volume constant. An output coil collar placed over

the more powerfull bearingless roter tube magnet has no upward output limit in proportion to it's increase in strength. Those Neo tubes have 60lb pull strenght.

[zebok13]

Awesome! Perhaps the magnet is using the opposite soft planetary pole. The coil actually has four poles: A posative and negative at the ends and a weaker adjacent opposite companion pole off to the side.

[jonnydavro]

Hi Zebok.Maybe you are right,it just seems to like running near the edge and is very stable here.Thats interesting info on the poles.Regards jonnydavro

[jonnydavro]

Hi bearicey.The snake egg can be powered from the top when using a master and slave coil setup,see vid 4.If you are thinking about using just one coil from above,i have not tried,but i will.Thanks for your comment regards jonnydavro

[Lidmotor]

Excellent!! I notice that you have the "egg" running off to the side of the coil. I found this to be the stable spot also. Great low amp draw. Next we will be running this off a lemon battery. Hummmm.

[jonnydavro]

Hi Lidmotor.Yes it seems to like running at the edge and this is where it uses least energy and i noticed yours does as well.Running on a lemon or two,i like it.

I think pirate may be able to get this running on an earth battery and that would be neat.

[zebok13]

The coil has four magnetic poles when energtized. Each axial pole attracts an opposite pole adjacent to it from the flux of the opposie pole below. So a cone flows up from each end then returns.

[Pirate88179]

Jonny:

Man, that is a low mA number you have there. Great work! This is unreal.

Bill

[jonnydavro]

Thanks Bill.When you get yours running how you want it,you may be able to run it from your earth battery as it seems it will run on very little power.Jonny

[GBluer]

4mA on 1.5v Great work Jonny

[jonnydavro]

Thanks Slayer.

[eroutt]

wow! 1.5v 4mA! i am shocked! good job!

[jonnydavro]

Thanks eroutt.With some tweaking it may go lower.

[ubuibiok]

★★★★★