5.10 ,i was just waiting on that screwdriver ending up stuck in you finger ,it was like a flash back from the past ,dont know how many times ive stabbed myself , ..any great videos ,thanks !
Good video, but you should never, ever mount an aluminum head on an iron block without resurfacing the head. Specially boosted engines. Good job though.
How do you know the notch on the bearing points toward the intake. Im assuming it says in the bentley manual. Im about to build a VRT and Im going to be using the manual. Just wanna make sure it says these little things in it. If it does then no worries.
Dude u fail at engine rebuilding!
U strip the block and u give it a proper wash!
Did u even check the warpage on the block deck and cylinder head??
marek0086 1 week ago
@marek0086 i wanna know... are you the man? or are you a pieceashitnogoodmotherfucker?
jazzpur 3 days ago
If you could upload the part 3 please i would greatly appreciate it
MegaMUKIMUKI 3 weeks ago
what are the benefits of doing this mod?
oranw 8 months ago
5.10 ,i was just waiting on that screwdriver ending up stuck in you finger ,it was like a flash back from the past ,dont know how many times ive stabbed myself , ..any great videos ,thanks !
spinlessbastard1 10 months ago
what the hell was that on the end?
themisfitsfan96 1 year ago
Good video, but you should never, ever mount an aluminum head on an iron block without resurfacing the head. Specially boosted engines. Good job though.
wallycastro3 1 year ago
at the end... wtf? Iron Sheik?
tobythesandwich 1 year ago 2
@tobythesandwich haha my hero
jazzpur 1 year ago
How do you know the notch on the bearing points toward the intake. Im assuming it says in the bentley manual. Im about to build a VRT and Im going to be using the manual. Just wanna make sure it says these little things in it. If it does then no worries.
kyleeski1 2 years ago
i believe the tang direction pays regard to the rotational direction of the motor.
my bently didnt state that detail...the 1.8t motors with tanged bearings happened to be that way...so i did the same
jazzpur 2 years ago
@jazzpur~ RedLine Assembly Lube is the way to go.
marek0086 1 week ago
Very thourough vids. Good job.
jjrock5 2 years ago
Hey for some reason it keeps saying 'an error occurred, please try again later.'
V21W 2 years ago
19mm...its an AWW motor in the video
jazzpur 2 years ago
what size rist pins are the ones you use in the video?
20PsiNow 2 years ago