The "on lathe" portions probably would add up to about an hour if I was just turning and not explaining as I go. The pendant takes as long as the other parts put together. :) The time for the preparation steps would vary widely depending on whether I was just making one or milling stock out for 10. It might take me 15 minutes to set up the drill press fence and stops but then the actual boring of the holes would only take a couple of minutes for each piece.
nice job
5937824 1 year ago
cut your nails!
Diablo8900 1 year ago
AHHH.. where is Part 4... i want to see it all done....dont let us hanging....????
asdblue333 2 years ago
Il be that good one day :-)
asdblue333 2 years ago
in all... including everything how long did it take you to do this? it is sweet =)
WarriorTheyHate101 2 years ago
Hi:
The "on lathe" portions probably would add up to about an hour if I was just turning and not explaining as I go. The pendant takes as long as the other parts put together. :) The time for the preparation steps would vary widely depending on whether I was just making one or milling stock out for 10. It might take me 15 minutes to set up the drill press fence and stops but then the actual boring of the holes would only take a couple of minutes for each piece.
bobham5 2 years ago
I would say that 1 1/2 hours would be a close estimate of actual time.
bobham5 2 years ago